Page 1
Channel Vision
Limited Warranty
Channel Vision Technology will repair or replace any defect
in material or workmanship which occur during normal use
of this product with new or rebuilt parts, free of charge in
the USA, for two years from the date of original purchase.
This is a no hassle warranty with no mail in warranty card
needed. This warranty does not cover damages in
shipment, failures caused by other products not supplied
by Channel Vision Technology, or failures due to accident,
misuse, abuse, or alteration of the equipment. This
warranty is extended only to the original purchaser, and a
purchase receipt, invoice, or other proof of original
purchase date will be required before warranty repairs are
provided.
Mail-in service can be obtained during the warranty period
by calling (800) 840-0288 toll free. A Return Authorization
number must be obtained in advance and can be marked
on the outside of the shipping carton.
This warranty gives you specific legal rights, and you may
have other rights (which vary from state to state). If a
problem with this product develops during, or after, the
warranty period, please contact Channel Vision, your
dealer, or any factory-authorized service center.
HDTV Multiswitch
C-1158 (SAT-HD58)
234 Fischer Avenue • Costa Mesa, CA 92626
(714) 424-6500 • (800) 840-0288 • (714) 424-6510 fax
www.channelvision.com • email: sales@channelvision.com
© 2002, Channel Vision™
Page 2
Model C-1158 (Sat-HD58) Features/Instructions:
- Install two coax from LNB 101 and two coax from LNB 119 (RG-6
min) into #C and #D ports of the C-1158 (Sat-HD58). Remove
4 x 4 switch, if existing.
- The bottom port is for terrestrial or local ANT/CATV and has a 2 to
3dB loss. Combine all on one coax to each TV location. A diplexer
(SAT-D2) must be used at each TV location.
- Accommodates eight satellite receivers.
- Passes local ANT HDTV.
- Snaps into Channel Vision Central enclosures, model C-0112,
C-0119, C-0138, and C-0150.
- Can be purchased as a stand alone part (SAT-HD58)
Wiring:
RG-6 min or quad/ RG-11 depending on distance
119 Degree 101 Degree
A
B
C
D
Cable or
Antenna
SAT HD 58
A
B
C
D
DUO DISH LNB 119/LNB 101
CVT 15PIA
Pre amp may be needed
119 Degree 110 Degree 101 Degree
C-KIT SWITCHER
C-KIT 110 upgrade
(for existing Direct Plus dish)
B
C
D
Cable or
Antenna
SAT HD 58
2-22 KHz Tone Generators
on High side of switch
Sold seperatly
A
B
C
D
(Direct TV Product)
Note: When the 110 LNB is added to the Direct TV Dish, you must add two
22 kHz Tone Generators (Channel Vision Part # SAT-22T) to the high side of
the SAT-HD58 (port C/D)
119 Degree 110 Degree 101 Degree
RCA
5x4 integraded switch
BUILT IN TO THE ARM
OF DIRECT TV DISH
2-22 KHz Tone Generators
on High side of switch.
sold seperatly Channel vision part #Sat 22 T
The New 5x4 Integraded
Switch/Dish by RCA
SAT HD 58
#SAT-22T
Loading...