Channel Vision LCR525 Instructions Manual

Channel Vision Technology will repair or replace any defect in

material or workmanship which occurs during normal use of this

p

roduct with new or rebuilt parts, free of charge in the USA, for ten

years from the date of original purchase. This is a no hassle warranty

with no mail in warranty card needed. This warranty does not cover

damages in shipment, failures caused by other products not supplied

by Channel Vision Technology, or failures due to accident, misuse,

abuse, or alteration of the equipment. This warranty is extended only

to the original purchaser, and a purchase receipt, invoice, or other

p

roof of original purchase date will be required before warranty

repairs are provided.

Mail in service can be obtained duringthe warranty period by calling

[phone] toll free. A Return Authorization number must be

obtained in advance and can be marked on the outside of the shipping

carton.

This warranty gives you specific legal rights and you may have other

rights (which vary from state to state). If a problem with this product

develops during or after the warranty period, please contact Channel

Vision Technology, your dealer or any factory-authorized service

center.

500-077 rev B

10

www.channelvision.com

234 Fischer Avenue, Costa Mesa, California 92626 USA

[phone] [phone] [phone] fax

email: [e-mail]

LCR525

5.25” In-Wall Left-Center-Right Speaker

8

2

Model LCR525

Installation:

h

h

h

h

h

Use the included template to mark and cut a hole in the
drywall.

We recommend wiring with AWG 16 or larger, stranded
wire.

For proper phasing, all speakers in the system must be
wired alike. Connect red wires to red terminals on
speaker and to red or plus terminals on amplifier.

Install LCR525 in hole. Tighten the mounting screws. The
mounting dog ears will rotate outward and grip the
drywall.

Aim tweeter

Mounting screws (6)

3

Specifications:

Frequency range:

Sensitivity:

Power Handling:

Drivers:

Impedance:

Finish:

Dimensions:

40Hz - 20kHz ± 3dB

88dB (1W/1m)

100-Watts Peak

1- 19mm Mylar tweeter
2- 5.25” polypropylene woofer with

18.6 oz. magnet

8 ohms

ABS plastic

7.64”H x 14.33”W x 4.21”D

(from surface of wall board)

Specifications subject to change without notice.

Features:

High power handling capacity

Dual 5.25” polypropylene woofers with butyl rubber
surrounds

1” pivoting Mylar tweeter

Gold speaker terminals

Video shielded drivers

Small perforated designer grille

Mounting template and paint shield included

Recommended power: 20W to 100W