Channel Vision IW601 User Manual

p

p

10

Channel Vision Technology will repair or replace any defect in

material or workmanship which occurs during normal use of this

roduct with new or rebuilt parts, free of charge in the USA, for ten

years from the date of original purchase. This is a no hassle warranty

with no mail in warranty card needed. This warranty does not cover

damages in shipment, failures caused by other products not supplied

by Channel Vision Technology, or failures due to accident, misuse,

abuse, or alteration of the equipment. This warranty is extended only

to the original purchaser, and a purchase receipt, invoice, or other

roof of original purchase date will be required before warranty

repairs are provided.

Mail in service can be obtained during the warranty period by calling

[phone] toll free. A Return Authorization number must be

obtained in advance and can be marked on the outside of the shipping

carton.

This warranty gives you specific legal rights and you may have other

rights (which vary from state to state). If a problem with this product

develops during or after the warranty period, please contact Channel

Vision Technology, your dealer or any factory-authorized service

center.

www.channelvision.com

234 Fischer Avenue, Costa Mesa, California 92626 USA

[phone] [phone] [phone] fax

email: [e-mail]

500-203rev A1

IW601

6.5” IN-Wall SPEAKER

8

Model IW601

Mounting screws (6)

Installation:

Use the included template to mark and cut a hole in the

h

drywall.

We recommend wiring with AWG 16 or larger, stranded

h

wire.

For proper phasing, all speakers in the system must be

h

wired alike. Connect red wires to red terminals on
speaker and to red or plus terminals on amplifier.

Features:

High power handling capacity

2nd order crossover 12dB per octave with poly switch for

tweeter protection.

6.5” polypropylene woofer with butyl rubber surround

1” pivoting soft dome tweeter

Gold speaker terminals

Small perforated designer grille

Mounting template and paint shield included (rough-in

bracket sold separately model: IW65B)

Recommended power: 20W to 100W

Specifications:

Frequency range:

Sensitivity:

Power Handling:

Drivers:

Impedance:

Finish:

45Hz - 20kHz ± 3dB

90dB (1W/1m)

150-Watts Peak

1- 1” soft dome tweeter
1- 6.5” polypropylene woofer

8 ohms

ABS plastic

Install the IW601 in the hole. Tighten the mounting

h

Dimensions:

screws. The mounting dog ears will rotate outward and
grip the drywall.

Aim tweeter

h

2

Hole Size:

12.0”H x 8.75”W x 3.44”D*

*from surface of wall board

10.625”H x 7.25”W

Specifications subject to change without notice.

3