10
Channel Vision Technology will repair or replace any defect in
material or workmanship which occurs during normal use of this
product with new or rebuilt parts, free of charge in the USA, for ten
years from the date of original purchase. This is a no hassle warranty
with no mail in warranty card needed. This warranty does not cover
damages in shipment, failures caused by other products not supplied
by Channel Vision Technology, or failures due to accident, misuse,
abuse, or alteration of the equipment. This warranty is extended only
to the original purchaser, and a purchase receipt, invoice, or other
proof of original purchase date will be required before warranty
repairs are provided.
Mail in service can be obtained during the warranty period by calling
(800) 840-0288 toll free. A Return Authorization number must be
obtained in advance and can be marked onthe outside of the shipping
carton.
This warranty gives you specific legal rights and you may have other
rights (which vary from state to state). If a problem with this product
develops during or after the warranty period, please contact Channel
Vision Technology, your dealer or any factory-authorized service
center.
Bose is a registered trademark of Bose Corporation, all rights reserved.
500-148 rev B2
C-1331
Mounting Bracket For Bose Amplifiers
R
C-1332
Hinged Mounting Plate For Bose Amplifiers
R
C-1355
50” Extender Ring For Bose Amplifiers
R
The C-1331, C-1332, and C-1355 are accessories that extend the depth
of Channel Vision’s 50” enclosure and allow Bose whole-house audio
R
equipment to be mounted inside.
Installing the C-1332
Note: Bose amplifiers sold separately.
1. Attach the Bose amplifier to the back side of
R
R
the C-1332 Hinged Mounting Plate.
Assembling the C-1355
1 Attach the long extension pieces to
the left and right side of the enclosure
as shown using the 10-32 x 0.375” screws.
Note that the left and right
pieces are not identical.
Install them as shown.
2. Attach the short extension pieces
to the top and bottom of the enclosure
as shown using the 10-32 x 0.375” screws.
4 screws
10-32 x 1”
2. Attach this assembly to the C-1355
(shown below).
Installing the C-1331
1. Attach the Bose amplifier to the front
side of the C-1331 Mounting Bracket.
2. Mount this assembly in the enclosure using
the snap pins (shown below).
R
Shown here
assembled
4 screws
10-32 x 0.375”
Attach the C-1332 to the left extension
Note: The top and bottom
sections of the C-1355
have mounting holes for
the optional C-1334 fan kit.
piece using the screws provided.
Note: There are 6 possible locations where the C-1332
Hinged Mounting Plates can be attached to the C-1355 Extender Ring.
This provides the installer with multiple mounting options. However, to
maintain proper operating temperatures, no more than 4 amplifiers
2
should be installed at one time.
3
Loading...