Channel Vision C-1324 User Manual

CHANNEL VISION

gy

Limited Warranty

Channel Vision Technology will repair or replace any defect in

material or workmanship which occurs during normal use of this

product with new or rebuilt parts, free of charge in the USA, for two

years from the date of original purchase. This is a no hassle warranty

with no mail in warranty card needed. This warranty does not cover

damages in shipment, failures caused by other products not supplied

by Channel Vision Technology, or failures due to accident, misuse,

abuse, or alteration of the equipment. This warranty is extended only

to the original purchaser, and a purchase receipt, invoice, or other

TM

CVHANNEL ISION

Central

C-1324

Universal Hinge Kit

proof of original purchase date will be required before warranty

repairs are provided.

Mail in service can be obtained during the warranty period by calling

[phone] toll free. A Return Authorization number must be

obtained in advance and can be marked on the outside of the shipping

carton.

This warranty gives you specific legal rights and you may have other

rights (which vary from state to state). If a problem with this product

develops during or after the warranty period, please contact Channel

Vision Technology, your dealer or any factory-authorized service

center.

500-095 RevB

[phone] [phone] [phone] fax

www.channelvision.com email: sales @ channelvision.com

© 2004 Channel Vision Technolo

CVHANNEL ISION

234 Fischer Avenue Costa Mesa, CA 92626

··

·

·

TM

The C-1324 is a universal hinge kit that allows a conventional

3

cover to hinge open. It is compatible with all of Channel Vision’s
regular in-wall structured wiring enclosures.

Features:

!

Compatible with exiting installations

!

Lock and key set included

!

Quick and easy installation

.

Attach cover to the enclosure:

Use the screws provided with your cover to attach the hinges.

A

A

Installation:

1.

Attach hinges to the cover:

Note the top and bottom hinges are NOT identical.

Top Hinge Bottom HingeMiddle Hinge

Only used for

38” & 50” covers

2.

Install the lock:

On the cover, remove the lock knockout and assemble as shown.
Note: covers made prior to the release of this product
will not have a knockout. To install the lock, drill a hole 11/16” in
diameter, located 1-9/16” in from the edge of the cover.

C

L

1-9/16”

B

B

C

C

4.

Install standoffs:

Screw in the plastic standoffs on the non-hinged side of the enclosure.

D

D

E

E

F

F

2

3