Page 1
10
Channel Vision Technology will repair or replace any defect in
material or workmanship which occurs during normal use of this
product with new or rebuilt parts, free of charge in the USA, for ten
years from the date of original purchase. This is a no hassle warranty
with no mail in warranty card needed. This warranty does not cover
damages in shipment, failures caused by other products not supplied
by Channel Vision Technology, or failures due to accident, misuse,
abuse, or alteration of the equipment. This warranty is extended only
to the original purchaser, and a purchase receipt, invoice, or other
proof of original purchase date will be required before warranty
repairs are provided.
Mail in service can be obtained during the warranty period by calling
(800) 840-0288 toll free. A Return Authorization number must be
obtained in advance and can be marked on the outside of the shipping
carton.
This warranty gives you specific legal rights and you may have other
rights (which vary from state to state). If a problem with this product
develops during or after the warranty period, please contact Channel
Vision Technology, your dealer or any factory-authorized service
center.
CVHANNEL ISION
Central
INPUT
C-0410
TM
TELEPHONE LIGHTNING PROTECTION
OUTPUTS
AUTOMATICALLY RESETS
Exceeds FCC part 68 type A+B and UL parts 1459 & 1950
C-0410
Phone surge protection module
500-065 RevC1
Page 2
From
Telephone Company
Model C-0410
Telephone surge protection module
C-0410
CVHANNEL ISION
Central
TM
TELEPHONE LIGHTNING PROTECTION
Features:
Protects against phone line transients caused by lighting,
power cross, and other conditions.
Exceeds FCC Part 68 A and Type B lightning immunity
requirements.
OUTPUTS
(see below)
INPUT
C-0410
INPUT
AUTOMATICALLYRESETS
Exceeds FCC part 68 type A+B and ULparts 1459 & 1950
SERVICE
OUTPUT
G-Kit 5
(wall plate kit)
TM
CVHANNEL ISION
Central
C-0432
C-0432
(telephone distribution)
Telephone
Installation:
Punch down as many as 4 incoming telephone lines on the
input 110 punch-down as shown. Use a 110 punch-down
tool to seat and trim all wires
Note position of cutter
Bellcore 1 compliant (GR-1089) (2500V@500amps)
Easily connects to phone distribution modules using: C0408 or C-0409 jumper cables
Snaps easily into Channel Vision Central enclosures: C0112E, C-0119E, C-0138E, and C-0150E.
Suggested wiring:
CAT5 wire from distribution to wallplate
CAT5 interconnects (models C-0408 and C-0409)
Specifications:
Telco inputs:
1-110 punch-down
Connect any of the telephone outputs to wall plates in each
room (see diagram).
2
Outputs:
Dimensions:
2 (1-RJ45 and 1-110)
3.0”L x 6.38” W x 1.75” D
Specifications subject to change without notice.
3
Loading...