Channel Vision C-0314 User Manual

Channel Vision

Limited Warranty

Channel Vision Technology will repair or replace any defect
in material or workmanship which occur during normal use
of this product with new or rebuilt parts, free of charge in the
USA, for one year from the date of original purchase. This
warranty does not cover damages in shipment, failures
caused by other products not supplied by Channel Vision
Technology, or failures due to accident, misuse, abuse, or
alteration of the equipment. This warranty extends only to
the original purchaser. A purchase receipt, invoice, or other
proof of original purchase date will be required before
warranty repairs are provided.

Mail in service can be obtained during the warranty period by
calling toll free [phone]. A Return Authorization
number must be obtained in advance and be marked on the
outside of the shipping carton.

This warranty gives you specific legal rights, and you may
have other rights which vary from state to state. If a problem
with this product develops during or after the warranty
period, please contact Channel Vision, your dealer, or any
factory-authorized service center.

Central

C-0314

8dB RF Amplified Splitter

© 01/99, CHANNEL VISION™

234 FISCHER AVENUE l COSTA MESA, CA 92626

[phone] l [phone] l [phone] FAX

HTTP://WWW.CHANNELVISION.COM l E-MAIL: [e-mail]

Description

Channel Vision’s 8dB power injected amplifier increases the strength of the
incoming cable or antenna signal. The increased signal strength means that
you can distribute the television signal longer distances and to more outputs.
Unlike most RF amplifiers, the C-0314 uses an external power supply that
can be connected directly to the unit using a coax “F” connector. For added
versatility the power injection feature was removed so we could pass IR.

Standard Wiring Layout

Cable or
Antenna

CHANNEL VISION

CentralCentral

C-0314

output

Instructions

Step 1: Snap the C-0314 into C-0112,C-0119,C-0138,C-0150 chassis of your

choice.

Step 2: Connect the incoming cable or antenna line to the INPUT port.
Step 3: Connect the outgoing coax cable to the OUTPUT port to distribute the signal

to 4 TV locations or a passive splitter.

Step 4: Connect the power transformer to the DC12V INPUT.

Please Note:

The unused trunk line connector or unused output of the last outlet device in each
trunk line MUST BE TERMINATED using a 75Ω terminator (model 2101).

Specifications

Bandwidth 45-1000Mhz

Gain 8dB +/-1.5

Flatness +/-1dB

Return Loss (min) 14dB

Return 5-42Mhz

Dist. X-Mod. -70dB

CTB -65dB

Power Supply 12V/55mA

Warning

To prevent fire or shock hazard, do not

expose this appliance to rain or moisture