
CHAN NEL VISIO N
TM
system
AB-114 / AB-202
AB-404 / AB-301
AB-T2454
Multi-room audio
distribution system
TM
2
1
by
CHA NNE L VI SIO N
R
By C HAN NEL V ISI ON
TM
STATUS
12VDC
3
TM
STATUS
IR EMITTERS
4
BRN
WHT/BRM
BLU
WHT/BLU
GRN
WHT/GRN
ORG
WHT/ORG
IR
IR emitters
Line level inputs
IN
AB-202
CHAN N E L V I SION
OUT
AUDIO
L
A-BUS OUTPUT
TM
234 Fischer Avenue · Costa Mesa, CA 92626
(714) 424-6500 · (800) 840-0288 · (714) 424-6510 fax
www.channelvision.com · email: sales @ channelvision.com
© 2004 Channel Vision Technology

The Channel Vision A-BUS system
can distribute high-quality audio to every room in your house over
ordinary CAT5 data wire. Power for the entire system is delivered via
the same CAT5 cable so only a single run of CAT5 is required. Each
pair of speakers is powered and controlled from a local wall plate with
a dedicated amplifier for that zone. Volume in that zone can be
controlled manually or by an infrared remote. IR signals are also
routed back to the source components enabling control of sources and
functions from any zone.
Required components
R
By C HAN NEL V ISI ON
2
TM
STATUS
12VDC
TM
IR EMITTERS
3
STATUS
4
IR
BRN
WHT/BRM
BLU
WHT/BLU
GRN
WHT/GRN
ORG
WHT/ORG
AB-202 ... Single source module. 1 per
system. Interfaces sources to the
system. Mount near audio components
(CD player, receiver etc.)
AB-404 ... Distribution module. 1 per
every 4 amplified keypads. All CAT-5
cables terminate here. Also inserts
power. Mount in a structured wire panel
or screw to a wall. Compatible with
panels from Channel Vision Central ,
OpenHouse , OnQ , or Leviton .
TM TM TM
TM
AUDIO
L
AB-202
A-BUS OUTPUT
OUT
IN
1
by
CHA NNE L VI SIO N
AB-114 amplified keypad ... 1 per
speaker pair. Drives the speakers,
controls volume and relays IR
information. Mount the AB-114 in single
gang low-voltage ring or deep J-box (if
required by code). Blue LEDs show
volume level. Keypad completely mutes
when bottom LED is off. (No amplifier
hiss like some other non-A-BUS
systems.)
AB-T2454 ... Power supply. 1 per every
AB-404. 120-240VAC
2

IR emitters
Line level inputs
Optional components
AB-301 ... Universal input module. Can be
used to provide local source input in any
room and/or to replace the AB-202. The
AB-301 is a great way to enable simple
connection of local sources into the zone TV’s, MP3 players, computer sources, etc.
Tuner
VCR
Channel Vision
AB-500
DVD TV
CD Sat
Ch
TM
0
Learn
All Off
Vol
OffSelect
Error
How IR repeating works
Point any
IR remote control
at the AB-114
Power
Select
Learn
T
uner
All Off
VCR
CD
Off
DVD
Sat
Channel V
TV
AB-500
ision
TM
Power
Learn
4
7
1 2
Stop
5
8 9
Pause
-/--
6
3
AB-500 ... Universal remote control.
Rew<< Play> FF>>
Tx Batt
Comes pre-programmed to control the
volume of the AB-114. Learns IR codes for
up to 6 sources.
IR-3001 & IR-3002 ... Single and dual
head IR flashers. Use one head per
source to control from the remote room.
(IR-3002 shown).
5019 ... Status power supply. Plugs into
switched outlet of receiver. When the
receiver is turned off, the entire system
mutes. (If a supply is plugged into the
status input, and is not powered, the
system mutes.)
The top LED flashes as IR
information is received.
Rew<<
Tx
Batt
Learn
Play>
Stop
FF>>
1
Pause
2
4
3
7
5
8
6
9
0
Ch
-/--
V
ol
Error
CD player
And the flasher
repeats the IR signal
in the other room.
Be sure the flasher is attached directly over
the component’s IR receiver.
3

Basic system
In this system
Four rooms listen to the same audio program. Each room
has independent volume controls.
Using the IR option, you can control the components from
any room. You can change the system input from FM to
the CD player, select another satellite radio station, or
pause the CD.
Using the status option, the systems mutes and conserves
power when the receiver is off. When the receiver is
turned back on, all amplified keypads return to the last
volume level.
(See corresponding numbers on opposite page)
1
Loop out ... Use this to expand to an additional AB-404.
This connector only provides audio signals to an additional
AB-404. It cannot be used to directly connect a 5th AB-114
to the system.
2
Cat-5 cables ... Follow color codes as shown.
Use 110 punch down tool only. (Never use a screwdriver to
punch down UTP wires. It will give intermittent connections
and damage or destroy the 110 connector.)
3
Volume indicators... The LEDs indicate the volume level. If
the Status is <off>, the LEDs will be dark. Pressing the
UP/DOWN keys will light the LEDs for a short period to show
the stored volume level.
Single zone system ... This is a single zone system. Even
though there are 4 pairs of speakers being driven, there is only
one source being fed to them at a time. All speakers play the
same audio. Easy to use, single zone systems are ideal for all
public spaces (kitchen, entry, family room, patio). Imagine
walking from room to room and your music follows. If music is
part of your life, the Channel Vision A-BUS system will make
music a part of your house.
4