Page 1
Specifications:
Image Sensor:
Picture Elements:
Resolution:
S/N Ratio:
Min Illumination:
Electronic Shutter:
Gain Control:
Auto White Balance:
Gamma Characteristic:
Camera Lens:
Sync. System:
Power Requirements:
Power Consumption:
Video Output:
Operating Temp:
Sony 1/3” Super HAD
NTSC: 510x492
380 lines
More than 48 dB
0.2 LUX @ F2.0
1/60s - 1/100,000s
Automatic
Color Temperature: 2500K-9500K
0.45
3.6mm / F2.0
Internal, Negative sync.
12VDC
145 mA
1 Vp-p @ 75 ohms
-10°C to 50°C (14°F to 122°F)
Specifications subject to change without notice.
CHANNEL VISION
Limited Warranty
Channel Vision Technology will repair or replace any defect in material or
workmanship which occurs during normal use of this product with new or rebuilt
parts, free of charge in the USA, for two years from the date of original purchase. This
is a no hassle warranty with no mail in warranty card needed. This warranty does not
cover damages in shipment, failures caused by other products not supplied by
Channel Vision Technology, or failures due to accident, misuse, abuse, or alteration
of the equipment. This warranty is extended only to the original purchaser, and a
purchase receipt, invoice, or other proof of original purchase date will be required
before warranty repairs are provided.
Mail in service can be obtained during the warranty period by calling (800) 840-0288
toll free. A Return Authorization number must be obtained in advance and can be
marked on the outside of the shipping carton.
This warranty gives you specific legal rights and you may have other rights (which
vary from state to state). If a problem with this product develops during or after the
warranty period, please contact Channel Vision Technology, your dealer or any
factory-authorized service center.
500-139 rev B
6115
Small Outdoor Color Dome Camera
8
Page 2
The is a small outdoor color dome camera. It is perfect
g
611
6115
for CCTV applications that require mounting flexibility. Its
small size and unobtrusive design make it perfect for
residential use.
Features:
High quality 1/3” Sony Super HAD CCD sensor
h
Digital Signal Processor (DSP) chip-set provides image
h
control
High sensitivity, low smear, high anti-blooming and high
h
S/N ratio
Automatic Gain Control (AGC) and Auto White Balance
h
(AWB)
3-Axis mechanism for easy rotation and adjustment
h
1. Connect wiring
2. Mount base
BNC connector
Model
3. Adjust camera
4. Attach dome
Coax extension
(not included)
5
(see page 2)
Finished
2-Conductor power
supply extension
(not included)
Crimp-on splice
connectors
(not included)
Dome Camera
Adjusting the 3-Axis Mount
To p
To p
Tilt
1. Tilt camera to
2
desired angle
Hex Wrench
Rotate
2. Rotate camera to
desired direction
Power Supply
Screws & Wall Anchors
To p
Rotate
3. Rotate camera ring
so that the image
appears ri
ht side up
To Monitor
or
Video distribution
Power supply
(included)
Installation:
Use the hex wrench to remove the dome cover from the
h
base.
Drill a hole in the wall or ceiling for wiring (see diagram).
h
If necessary, attach the camera’s video output to a coax
h
extension that is long enough to reach your monitor or
video distribution equipment.
If necessary, cut the connector off of the end of the power
h
supply and splice in an extension using crimp-on
connectors.
Mount the base with the provided screws.
h
Move the camera body to adjust the view.
h
Attach the dome and secure it with the hex wrench.
h
3
Loading...