Channel Vision 5125 User Manual

CHANNEL VISION

Limited Warranty

Channel Vision Technology will repair or replace any defect in

material or workmanship which occurs during normal use of this

product with new or rebuilt parts, free of charge in the USA, for two

years from the date of original purchase. This is a no hassle warranty

with no mail in warranty card needed. This warranty does not cover

damages in shipment, failures caused by other products not supplied by

Channel VisionTechnology, or failures due to accident, misuse, abuse,

or alteration of the equipment. This warranty is extended only to the

original purchaser, and a purchase receipt, invoice, or other proof of

original purchase date will be required before warranty repairs are

provided.

Mail in service can be obtained during the warranty period by calling

[phone] toll free. A Return Authorization number must be

obtained in advance and can be marked on the outside of the shipping

carton.

This warranty gives you specific legal rights and you may have other

rights (which vary from state to state). If a problem with this product

develops during or after the warranty period, please contact Channel

Vision Technology, your dealer or any factory-authorized service

center.

500-10

3

Black & White

IR illuminated Camera

234 F

ISCHER AVENUE •C

[phone] • [phone] • [phone] fax

www.channelvision.com • email: [e-mail]

© 2005, CHANNEL VISION™

OSTA MESA, CA 92626

Model 5125

2

Model 5125

Coax extension

(not included)

Power supply

(included)

To Monitor

or

Video distribution

Power

2-Conductor power

supply extension

(not included)

Crimp-on splice

connectors

(not included)

Side view

Front view

Video

(BNC connector)

Installation:

h

h

h

h

Attach the camera mount to a wall or ceiling using the 3
screws provided.

Drill a hole in the wall or ceiling for wiring (see diagram).

If necessary, attach the camera’s video output to a coax
extension that is long enough to reach your monitor or
video distribution equipment.

If necessary, cut the connector off of the end of the power
supply and splice in an extension using crimp-on
connectors.

3

Specifications:

Camera Lens:

Resolution:

S/N Ratio:

Min Illumination:

Power Supply:

Power Consumption:

Video Output:

Scanning System:

Waterproof criterion:

Dimensions:

Operating Temp:

3.6mm

420 lines

More than 48 dB

0.5 LUX @ F2.0 (Before IR is activated)

12VDC regulated

210 mA

1 Vp-p @ 75 ohms

interlaced 2:1

IP 67

2.1”Dia. x 2.3”L (body only)

-10°C to 50°C (14°F to 122°F)

Specifications subject to change without notice.

Features:

1/3” Sony CCD

420 Lines Of Resolution

0 Lux Sensitivity

3.6mm Lens

Power Supply Included

U-shaped mount Included

Weatherproof

Sun Shield Included