Channel Master Titan 2 Preamplifiers User Manual [es, fr, en]

TITAN 2

preamplier series

™

USER GUIDE

GUÍA PARA
EL USUARIO

CM-7777 CM-7778

MODE

D’EMPLOI

This page intentionally left blank.

Table of Contents

Product Overview ....................................................................3

Package Contents and Accessories .....................................3

Installation .................................................................................4

Technical Data .........................................................................6

Product Return Policy and Warranty ..................................... 7

Índice

Perspectiva General del Producto ........................................9

Contenido del Paquete y Accesorios ...................................9

Instalación ...............................................................................10

Datos Técnicos ....................................................................... 12

Garantía y Póliza para la Devolución del Producto..........12

Index

Présentation du Produit .........................................................15

Contenu et Accessoires de L'emballage............................15

Installation ..............................................................................16

Données Techniques ............................................................. 18

Politique de Reprise de Marchandise et Garantie ............ 19

1

Montado en el Mástil de Antena Pre

For Weak Signal Areas

Para Areas con Señal Débil
Pour les Zones de Faible Signal

Montado en el Mástil de Antena Pre

CM-7777

Mast Mounted

Antenna Preamplifier

UHF/VHF/FM

Amplificador de UHF / VHF / FM

Monté sur Mât D'antenne Pré

Amplicateur UHF / VHF / FM

CM-7778

Mast Mounted

Antenna Preamplifier

UHF/VHF/FM

Amplificador de UHF / VHF / FM

Monté sur Mât D'antenne Pré

Amplicateur UHF / VHF / FM

For Moderate Signal Areas

Para las Áreas de señales moderadas
Pour les zones de signaux modérées

2

TITAN 2

™

Product Overview

The Channel Master TITAN 2™ CM-7777 preamplier is
a high gain, low noise preamplier used for weak signal
areas. The CM-7777 takes a weak signal that is present
at the antenna and amplies it to a viewable strength.
In areas with fairly strong signals, use our medium gain
preamplier (CM-7778). TITAN 2 Preamplier’s improved
gain is perfect if you anticipate distributing your signal with
a digital splitter to multiple outlets throughout your house
as splitters reduce the signal strength available at each
output. The new housing includes a combined VHF/UHF
input and a single output for a simpler indoor or outdoor
installation.

Product Features

• Amplication for both VHF and UHF bands

• High gain and low noise

• Includes switchable FM trap

• Amplies digital and analog signals

• Perfect for moderate (CM-7778) or weak (CM-7777)
signal areas

Package Contents and Accessories

All Titan 2™ ampliers include:

• Power Inserter

• Power Supply

• 6 ft Coaxial Cable

• Hardware

• User Guide

3

INSTALLATION

FM Switch

To change settings,
remove four screws
from the cover.

Out

In

1. Internal switch selection. If you

are using a single antenna for TV
signals only, there is no need to
adjust the internal switches in the
amplier.

NOTE: If you are using the antenna

for FM radio signals as well as TV,
then select the “OUT” position on
the FM trap switch. See Fig 1.

2. Using the U CLAMP, mount the

grey outdoor amplier to the mast
below the antenna. See Fig 2.

3. With a short length of coaxial cable (not included),

connect the antenna to the “INPUT” on the amplier.
See Fig 2.

4. Connect the down lead coaxial cable (not included)

to the connection labeled “OUTPUT/POWER.” Cable
tie the cable to the mast to prevent stress on the
connector.

5. Run the down lead coaxial cable (not included) into

the home to a location where an AC power outlet is
available. Connect this coax to the connection labeled
“TO AMP” of the power inserter. See Fig 2.

IMPORTANT: There should NOT be any signal splitters

located in this coaxial cable line between the outdoor
amplier and the indoor power supply. Splitters must be
located on the “TO TV” side of the power inserter. See

Fig 3.

6. Connect the coaxial cable (not included) that

distributes the signal to the TV to the “TO TV” port of
the power inserter and connect the power supply to
the “DC IN” port of the power inserter with the six foot

4

TITAN 2

™

coaxial cable (included). See Fig 2. Plug the power
supply into the AC outlet.

Amplier, Mast Mounted

Model 7777 or 7778

Model CM-94444 Balun (matching
outdoor transformer)

Antenna
terminals

75 Ohm cable from power
inserter to TV

Indoor power

75 Ohm cable from amp
to balun

POWER INSERTER

TO TV

PCT-MPI-1G

DC IN

supply

TO AMP

Power inserter

75 Ohm cable form
power inserter to
indoor power supply

Fig 2

U-bolt
assembly

75 Ohm
cable from
amp to
indoor power
inserter

Cable Tie

OUTSIDE HOME

INSIDE HOME

5

PREAMP

Model CM-7777 or CM-7778

4-WAY SPLITTER

MODEL CM-3214

BEDROOM

ATTIC

ANTENNA

POWER INSERTER
MODEL PCT-MPI-1G

BEDROOM

Typical Four Room

Installation

POWER SUPPLY
MODEL APA1260315U

DEN OR
KITCHEN

TV

TV

FM STEREO

TV

LIVING ROOM

TV

“O” DB WALL OUTLET
(TYPICAL)

FM SPLITTER

Features and Technical Data for
the Titan 2 Series

• Number of Inputs .... 1

• Input/Downlead ..... 75 Ohms

• Connectors ............. F

• Switchable FM trap

• Gain ......................... VHF 30 dB / UHF 30 dB (CM7777)

VHF 16 dB / UHF 16 dB (CM7778)

6

TITAN 2

Fig 3

™