Channel Enterprises TouchSense UA-07 User Manual

Channel Enterprises (H.K.) Ltd.

UA-07 TouchSense Bluetooth Headset User Manual 1

UA-07 TouchSense Bluetooth Headset User Manual

Introduction:

Thank you for choosing UA-07, TouchSense Bluetooth Headset. It supports

Bluetooth v2.1, which increase voice quality and product range, also reduce

power consumption.

Inside the package, we should find:

1x TouchSense Bluetooth Headset

1x Charger

1x User Guide

1x Ear Hook

1x Ear Cushion

Product Specification

Bluetooth Version V2.1 and with backward compatible V2.0, V1.2

and V1.1

Bluetooth Profile

Supported

Headset and Hands-free

Dimensions 48.5(L) x 17(W) x 10(H) mm

Weight 10 grams

Charging Time Around 1.5 hours

Talk Time Up to 7 hours

Standby Time Up to 160 hours

Product Range 10 meters with no obstructions

Operation Temperature

0-50℃

Battery Type and

Capacity

Rechargeable Li-Polymer 100mAh

Charging the headset:

Before using the headset, please insert the charger into the power source and

connect the other end to micro USB charging socket of the headset to charge

the battery fully.

To extend the battery life, we recommended re-charging the battery every 6

months. Charging indication will be delayed in a few seconds if the headset

has not been used for a long period of time.

Channel Enterprises (H.K.) Ltd.

UA-07 TouchSense Bluetooth Headset User Manual 2

Status Status Indicator Audio

1. Charging Red LED

2. Fully charged The LED goes off

3. Low battery Red LED for every

five seconds

A short beep every

20 seconds

Turning Your Headset On and Off:

Turning On the Headset

Press and hold the MFB until the LED flashes blue.

Turning Off the Headset

Press and hold the MFB until the LED flashes red.

Pairing Your Headset / Pairing Procedure:

The headset must be paired with the mobile phone (or other Bluetooth-enable

device) before use.

A. With a Bluetooth mobile phone

1. Turn on the Bluetooth function in the mobile phone.

2. Place the headset and the phone where they are visible, within arm’s

length from each other.

3. Ensure the headset is OFF.

4. Press and hold the MFB until the headset LED flashes blue and red

alternately, the headset is now at the pairing mode.

5. Search the headset by choosing the search function in the phone and

select “TouchSense”.

6. Enter “0000” if you are prompted to enter the passcode and press “OK”. If

yours supports Bluetooth v2.1, no code is required due to “Simple pairing”

function.

7. When pairing is complete, the LED will flash blue and follows by beeps. A

headset icon appears on the screen.

8. For some phones, you may need to manual press “connect” to connect the

headset.

9. If the pairing is not complete within about 2 minutes, the headset will

automatically go to standby mode and will turn off after 5 minutes. Do steps

2 through 7 repeatedly until succeed.