Changsha SunSky Electronic Design and Development SUNVOTEBASE12X User Manual

EA1200 FAST OPERATION MANUL

Status LED

Data LED

· The Status LED indicates the communication status with PC, when flash quickly, it

INDICATE LED

BASE STATION

CONNECTION

RADIO

CHANNEL SET

stands that it received the data from PC.

· When the Data LED light, it stands receiving data from keypad

· Connect the base station with PC USB port , the Status LED will flash every half

second if connection is successful.

· The Status LED will flash quickly after the software and base station communicate

normally.

· Initial installation, PC will automatically remind that have found new device and

install the drive automatically.

· After logging in application software, choose the new channel in the “channel” of

“base station set”, then click “set”.

· When using the multiple base station solution, the frequency channel of each base

station should be different, and it’s better not to set the neighboring channel

· Only when frequency channel is interfered or communication is not good, then you

need to consider changing and resetting the channel, usually you needn’t.

USB Port

BASE STATION

TEST

After connetion is ok, power on keypads, then do keypads testing.

FCC Caution.

§ 15.19 Labelling requirements.

This device complies with part 15 of the FCC Rules. Operation is subject
to the following two conditions:
(1) This device may not cause harmful interference, and
(2) this device must accept any interference received,
including interference that may cause undesired operation.

§ 15.21 Information to user.

Any Changes or modifications not expressly approved by the
party responsible for compliance could void the user's authority
to operate the equipment.

§ 15.105 Information to the user.

Note: This equipment has been tested and found to comply with
the limits for a Class B digital device, pursuant to part 15 of
the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation.
This equipment generates uses and can radiate radio frequency energy and,
if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no guarantee
that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following
measures:

-Reorient or relocate the receiving antenna.

-Increase the separation between the equipment and receiver.

-Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.

-Consult the dealer or an experienced radio/TV technician for help.

*RF warning for Mobile device:

This equipment complies with FCC radiation exposure limits set forth
for an uncontrolled environment. This equipment should be installed
and operated with minimum distance 20cm between the radiator & your body.