Changsha SunSky Electronic Design and Development SUNVOTEB3X Users Manual

MANUAL

Thanks for purchasing our product. Please read this manual carefully
before starting to use this device. When you use this device, you are supposed
to learn well of this product.

1. Connection

First confirm the install USB driver in your computer, then put PVS-3000
USB receiver to USB port on your computer. The status LED will twinkle every
half one second.

If your Computer isn’t installed the USB driver, it will prompt you a
new device found after putting PVS-3000 USB receiver in Computer, please
install USB driver and assure the correct installation.After installing USB
driver, please click “My computer” by the right key of mouse, and enter
“System property->hardware->device manager” to check if there is a new COM
port in “PORT (COM & LPT)”, and remember the COM Port.

From now on, the COM port will appear in “Device manager” after putting
in USB receiver, otherwise the installation is incorrect.

2. COM Port Set

Generally, when you use the system at the fist time or voting test is
incorrect, you should set the COM Port, other time you needn’t.After logging
in the application software, please check if the COM port number iscorrect
in “System set” or “Device set”. (If it can read USB receiver configures,
which means connection is successful, otherwise please check the COM
port.Maybe system software can support automatically COM port set, namely
find the USB receiver COM port automatically.

Note: Only when COM port is correct software can communicate with USB
receiver.

3. Radio Channel Set

When system channel is interfered or the communication is not good, you
need re-set the channel, other time you needn’t.After logging in application
software, choose the new channel in the “Channel” of“Base set”, then
click “set”, when channel set is successful, software will prompt toreceive
Base station configure.When using multiple USB receivers, the frequency
channel of each USB receiver must be not same, so it is better not to set
the neighboring channel.

4. Receiver test

After the above steps, please test by the keypads which are set ID numbers,
as USB receiver get the command from Computer continuously, therefore the
status LED twinkles fast, you can judge the USB receiver is receiving and
sending data.

FCC NOTE: THE MANUFACTURER IS NOT RESPONSIBLE FOR ANY RADIO OR TV INTERFERENCE
CAUSED BY UNAUTHORIZED MODIFICATIONS TO THIS EQUIPMENT. SUCH MODIFICATIONS
COULD VOID THE USER’S AUTHORITY TO OPERATE THE EQUIPMENT.

This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions: 1. This device may not cause harmful
interference, and 2. This device must accept any interference received,
including interference that may cause undesired operation.