Changhong Electric FTM520R02SD, FTM519R02WD User Manual

FROST FREE REFRIGERATOR

USER’S MANUAL

FTM520R02SD

FTM519R02WD

Please read the manual carefully before operation and keep it for reference.

IMPORTANT SAFETY INFORMATION

ELECTRICAL REQUIREMENTS

This appliance must be grounded.IN the event of electrical short circuit, grounding
reduces the risk of electrical shock by providing an escape wire for the electrical current.

This appliance is equipped with a cord having a grounding wire with a grounding

plug.The plug must be plugged into an outlet that is properly installed and grounded.

IMPORTANT WARNING

An empty refrigerator can pose a threat to children.
To render the unit harmless we strongly recommend removing the door prior to disposal.
DANGER:Risk of child entrapment.Before you throw away your old refrigerator or

freezer.

·Take off the doors

·Leave the shelves in place so that children
may not easily climb inside.

WARNING-Improper use of the grounding plug can result in a risk of electric
shock.Consult a qualified electrican or serviceman if the grounding instructions are not
completely understood,or if doubt exists as to whether the appliance is properly
grounded.

DO NOT USE AN EXTENSION CORD

Use an exclusive wall outlet.Do not connect your refrigerator to extension cords or
together with any other appliance in the same wall outlet.

INSTALLATION INSTRUCTIONS

Remove exterior and interor packings,wipe the outside thoroughly with a soft dry cloth
and the inside with a wet, lukewarm cloth. Avoid placing the unit in a narrow recess or
near any heat source,direct sunlight,or moisture.Let air circulate freely around the unit.
Keep the rear of the refrigerator 5 inches away from the wall.

Location

1) Select aplace with a strong,level floor.

2) Allow 5 inches of space between the back of the refrigeratoy and any adjacent wall.

3) Avoid direct sunlight and heat.Direct sunlight may affect the acrylic coating. Heat

sources nearby will cause higher electricity consumption.
The refrigerating system in this refrigerator is a “Frost Free” system .This type of system
requires no user intervention(i.e.defrosting) other than selecting required cooling
temperatures and the usual care and maintenance.
To avoid vibration,the unit must be set level.This is accomplished by adjusting the front
leveling leg,located under the refrigerator.

NOTES:

·This appliance is intened for FREE-STANDING INSTALLATION ONLY,and is NOT

intended to be built-in.

1

·Before connecting this appliance to electrical power supply, leave it to stand for

approx.24 hours,which will reduce the possibility of malfunction in the cooling system
due to transport handling.

·This appliance is approved for INDOOR USE ONLY and is NOT intended for outdoor

operation.

NOTE:

IF THE UNIT IS UNPLUGGED,HAS LOST POWER, OR IS TURNED OFF, YOU MUST
WAIT 3 TO 5 MINUTES BEFORE RESTARTING THE UNIT. IF YOU ATTEMPT TO
RESTART BEFORE THIS TIME DELAY,THE REFRIGERATOR-FREEZER WILL NOT
START.

Door handle installation

Separately set the two end covers handle in the handle seats of the freezer door, then
press the door handle on the door and push down with too much force. Then gently
support upwards with hands to check the handle whether fall off or not. Installing the
refrigerator door handle is using the same methods.
Note: The door handle cannot be reversed when installing, or it cannot be fixed up.

2

Freezer door
handle

Refrigerator
door handle

FEATURES

1) REFREEZER SHELVES

2) ICE CUBE TRAY

3) FREEZER TEMPERATURE CONTROL

4) REFRIGERATOR TEMPERATURE CONTROL

5) REFROGERATOR SHELVES

6) LLED LAMP

7) CRISPER COVER

8) CRISPER

9) FREEZER DOOR RACK

10) STORE THE KETTLE COMPONENTS

11) REFRIGERATOR DOOR UPPER RACK

12) REFRIGERATOR DOOR MIDDLE RACK

13) REFRIGERATOR DOOR BOTTOM RACK

3