Chaney Instrument VN1TXCA1 Users Manual

Professional Weather Center Model: VN1TXCA1 Quick Setup Guide
PROFRSSIONAL WEATHER CENTER:
01515DI
VN1TXCA1
Set up instructions step by step: Step 1:
Remove battery cover from the outdoor transmitter. Insert 4 NEW AA batteries (not included) into the transmitter. Observe the correct
polarity.
Keep the LCD display and transmitter within 10 feet during setup. Note: Use Alkaline batteries
(or Lithium for temperatures below - 20°F / -28.8°C).
Step 2:
Remove battery cover from Receiver Insert 6 NEW AA batteries (not included) into the back of the Receiver. Observe
the correct polarity (see marking inside the battery compartment).Do NOT mix old and new batteries.
The Clock will display, time (12:00) date (1/1) and indoor temperature etc.
Trouble shooting:
If after 3 minutes of waiting, the Outdoor temperature does not show up in the
designated area on the display, remove batteries from both units and start the setup process again.
For optimal reception performance, of the 433 MHz signal, the outdoor transmitter
should be placed within 330 feet (100 meters) from the Indoor LCD display.
CARE AND MAINTENANCE:
Do Not Mix Old and New Batteries Do Not Mix Alkaline, Standard, Lithium or Rechargeable Batteries  Do not expose the display to extreme temperatures, vibration or shock.  Keep display dry.  Clean display with a soft damp cloth. Do not use solvents or scouring agents.  The product is not a toy. Keep it out of reach of children.
The product is not to be used for medical purpose or for public information, but is
determined for home use only.
The specifications of this product may change without prior notice. Improper use or unauthorized opening of housing will void the warranty. If the unit does not work properly, change the batteries.
SPECIFICATIONS: Outdoor:
Temperature Range: -40°F to 158°F Outdoor Range: 1% to 99%
Wind Speed: 0 to 99mph Wind Direction Indicators: 16
Rainfall: 0 to 99.99in. Indoor:
Temperature Range: 32°F to 122°F Humidity Range: 16% to 98%
Backlight: Yes; Blue Backlight in momentary when weather center display unit is on battery power, always on or off when utilizing AC power adaptor (included).
Calibration: Yes The temperature and humidity readings on the weather center display may be calibrated. Rainfall can be manually calibrated on the 5-in-one wireless sensor. Basic tools reqired.
Wireless Distance: 330 ft. (100 meters) RF 433MHz (open air) Interval: About every 18 seconds
Power:
Transmitter: 6-AA, IEC, LR6 batteries (not included) Receiver: 4-AA, IEC, LR6 batteries (not included) AC Power: 4.5V adaptor (included)
WARRANTY INFORMATION La Crosse Technology, Ltd provides a 1-year limited warranty on this product against manufacturing defects in materials and workmanship.
This limited warranty begins on the original date of purchase, is valid only on products purchased and used in North America and only to the original purchaser of this product. To receive warranty service, the purchaser must contact La Crosse Technology, Ltd for problem determination and service procedures. Warranty service can only be performed by a La Crosse Technology, Ltd authorized service center. The original dated bill of sale must be presented upon request a s proof of purchase to La Crosse Technology, Ltd or La Crosse Technology, Ltd’s authorized service center.
La Crosse Technology, Ltd will repair or replace this product, at our option and at no charge as stipulated herein, with new or reconditioned parts or products if found to be defective during the limited warranty period specified above. All replaced parts and products become the property of La Crosse Technology, Ltd and must be returned to La Crosse Technology, Ltd. Replacement parts and products assume the remaining original warranty, or ninety (90) days, whichever is longer. La Crosse Technology, Ltd will pay all expenses for labor and materials for all repairs covered by this warranty. If necessary repairs are not covered by this warranty, or if a product is examined which is not in need or repair, you will be charged for the repairs or examination. The owner must pay any shipping charges incurred in getting the La Crosse Technology, Ltd product to a La Crosse Technology, Ltd authorized service center. La Crosse Technology, Ltd will pay ground return shipping charges to the owner of the product to a USA address only.
The La Crosse Technology, Ltd warranty covers all defects in material and workmanship with the following specified exceptions: (1) damage caused by accident, unreasonable use or neglect (including the lack of reasonable and necessary maintenance); (2) damage occurring during shipment (claims must be presented to the carrier); (3) damage to, or deterioration of, any accessory or decorative surface; (4) damage resulting from failure to follow instructions contained in the owner’s manual; (5) damage resulting from the performance of repairs or alterations by someone other than an authorized La Crosse Technology, Ltd authorized service center; (6) units used for other than home use (7) applications and uses that this product was not intended or (8) the products inability to receive a signal due to any source of interference.. This warranty covers only actual defects
within the product itself, and does not cover the cost of installation or removal from a fixed installation, normal set-up or adjustments, claims based on misrepresentation by the seller or performance variations resulting from installation­related circumstances. LA CROSSE TECHNOLOGY, LTD WILL NOT ASSUME LIABILITY FOR INCIDENTAL, CONSEQUENTIAL, PUNITIVE, OR OTHER SIMILAR DAMAGES ASSOCIATED WITH THE OPERATION OR MALFUNCTION OF THIS PRODUCT. THIS PRODUCT IS NOT TO BE USED FOR MEDICAL PURPOSES OR FOR PUBLIC INFORMATION. THIS PRODUCT IS NOT A TOY. KEEP OUT OF CHILDREN’S REACH.
This warranty gives you specific legal rights. You may also have other rights specific to the State. Some States do not allow the exclusion of consequential or incidental damages therefore the above exclusion of limitation may not apply to you.
FCC Statement
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: -Reorient or relocate the receiving antenna. -Increase the separation between the equipment and receiver. ­Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. -Consult the dealer or an experienced radio/TV technician for help. To assure continued compliance, any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate this equipment. (Example- use only shielded interface cables when connecting to computer or peripheral devices).
This equipment complies with Part 15 of the FCC Rules.Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation.
Caution!
The manufacturer is not responsible for any radio or TV interference caused by unauthorized modifications to this equipment. Such modifications could void the user authority to operate the equipment.
Canada Statement
This device complies with Industry Canada RSS-210. Operation is subject to the following two conditions: (1) this device may not cause interference, and(2) this device must accept any interference, including interference that may cause undesired operation of the device.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio RSS-210. L'exploitation est autorisée aux deux conditions suivantes : (1) l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d'en compromettre le fonctionnement.
Printed in China
1
Loading...