Chaney Instrument ACU-RITE 00593W User Manual

Instruction Manual
Owner’s Manual 00593W
Thank you for purchasing the new generation radio-controlled wireless weather clock. This unit is
designed and engineered with the state-of-art technology and components. This instrument will
provide accurate and reliable measurement including temperature and humidity tendency as well
as humidity and in/ outdoor temperatures. Please read this manual carefully to fully explore the
features and benefits of the new product.
Press Functions Hold 3 seconds
CHANNEL Select Channel 1, 2, 3 Delete current channel
PRESSURE View Pressure History for the past hr 0 to –12 hours
SET/ RCC Trigger R/C synchronization Enter clock & calendar
setting
“+” 1 step forward Fast advance
Alarm 1, 2 on/off
“-“ 1 step backward Fast backward, C/ F
Select Time zone
ALARM Read Alarm 1 Alarm time setting
Read alarm time 5 sec at normal mode
MEMORY Read maximum/ minimum temperatures, humidity & air pressure –
(reads both indoor/outdoor temperatures & humidity)
“P+” Step advance for pressure
“P-“ Step backward for pressure Select hPa/ inHg
SNOOZE Trigger snooze alarm
BATTERY INSTALLATION
For the first installation, insert batteries in the main unit first, then the remote sensor.
1. Insert 2 AA alkaline batteries into the main unit.
2. Insert 2 AAA alkaline batteries into the remote sensor.
SETTING UP THE WIRELESS THERMOMETER:
Always insert batteries into the home unit first and then the remote sensor. Your new RF
Thermometer is built with random security code technology. The home unit will learn the
random security code of the remote sensor and will be registered without being interfered
with by a neighbor who may be using the same type of sensor under the same channel
setting. The base unit can monitor up to 3 remote sensors at a time (One sensor is included
with this item.)
Lift off the rear cover of the remote sensor by separating front and back panels at the side
seam.
Place batteries in the sensor and press “TX” button to send a signal to the main unit. Select
temperature display at this time by pressing the “C/ F” button. Replace the back cover on
remote sensor.
MODE button on the inside of the remote sensor allows you to see the humidity and the
temperature. When you press the button once it will show the humidity when pressed again
it will show an arrow and that will scroll from temperature and humidity. When pressed again
than it will stay on temperature.
When replacing batteries for the remote sensor, remember to clear the corresponding
channel of the home unit in this way: Select the respective channel by pressing the
CHANNEL button then by holding the CHANNEL button for 3 seconds to clear the
registration.
Note: The “TX” and the “C/F” are hidden inside the protective backing to ensure weather resistance of this
unit that is intended for the outdoors. The remote sensors are not “waterproof” meaning able to submerse, but
rather water resistant or weather resistant. Prolonged exposure to cold weather may cause damage to the LCD
panel and in addition can drain your batteries. Extreme heat can cause your batteries to drain and more
importantly, explode and corrode in the compartment. Battery corrosion will harm the unit. Although these
units are intended for outdoor use, placing them in a protected area will preserve the life of the unit.
Loading...
+ 4 hidden pages