Chaney Instrument 13027 User Manual

Features

Congratulations on your purchase of an Acu-Rite Set and Forget digital alarm. The first
alarm clock to automatically display the time as soon as it is plugged in. The clock will
show the correct time in the Eastern Time Zone (default). Simply slide the switch to your
time zone and the time will adjust to your correct local time.

To Set DST (Daylight Savings Time)

To set the DST (On/Off), press the DST button once. Press the (+) or (-) button to turn
the DST function on or off. If the display shows (doN), DST is on and (doF) means DST
is off. After turning on the DST function the first time, DST will be updated
automatically. This simple setting method allow people living in areas that do no observe
DST to change their clock quickly and easily.
DST starts: First Sunday in April at 2am.
DST ends: Last Sunday in October at 2am.

To Set Time Zone

Slide the TIME ZONE switch located on the top of the clock to your time zone. To view
a time zone status on the display, just press the DST button twice and a time zone code
number will be shown at the right side of the display. Code key:
1 = East Standard Time (EST)
2 = Central Standard Time (CST)
3 = Mountain Standard Time (MST)
4 = Pacific Standard Time (PST)

To Set the Alarm

To set the alarm time, press the ALARM SET button once. The hour digits will blink.
Press the (+) or (-) button until the correct hour is displayed. Press the ALARM SET
button once again to set the minutes. The minute digits will begin to blink. Press the (+)
or (-) button as above. Be sure to set the AM/PM time properly or the alarm will sound at
the wrong time.

Snooze

Press the SNOOZE bar and get an extra 10 minutes of sleep. This may be repeated up to
four times.

To Operate Alarm

Slide the ALARM ON/OFF switch located on the top of the clock to the ON position.,
the alarm will sound at the time it is set for. To reset the alarm for the next day,
momentarily press the ALARM SET button. To shut off the alarm completely, slide the
ALARM ON/OFF switch to the OFF position.

To Manually Reset the Time

Some people prefer to set their clock ahead of the correct time. The following will allow
you to do so, if you wish. Should the clock ever lose the correct time, the same procedure
can be followed to set it correctly.
To set the time, press and hold the DST button for 5 seconds. The hour digits will begin
to blink. Press the (+) or (-) button to set the hour. Press the DST button again. The
minute digits will begin to blink. Press the (+) or (-) button to set the minutes. Continue
these steps to set the date and year also.

Backup Battery Replacement

This clock has 4 AG13/LR44 backup batteries installed at the factory. We suggest that
you replace the backup batteries at least every five years. This will allow the correct time
to be kept forever. When the unit is not plugged in, the backup battery will keep the
correct time for 11/2 years without the display showing.

To Read the Date and Year

Press the (+) or (-) button to display time, date, and year alternately. Press the (+) or (-)
button once to show Month & Date, press the (+) or (-) button twice to show Year, for
example, the display reading (y03) means the year is 2003.