REGISTER YOUR PRODUCT ONLINE
at championpowerequipment.com
OPERATOR'S MANUAL
MODEL #73500i
PARALLEL OPERATION KIT
or visit championpowerequipment.com
READ AND SAVE THIS MANUAL. This manual contains important safety precautions which should be read and understood before operating the product.
Failure to do so could result in serious injury. This manual should remain with the product.
Specifications, descriptions and illustrations in this manual are as accurate as known at the time of publication, but are subject to change without notice.
WARNING: Cancer and Reproductive Harm – www.P65Warnings.ca.gov
Made in China - REV 20190923 Champion Power Equipment, Inc., Santa Fe Springs, CA USA
73500I - PARALLEL OPERATION KIT
ASSEMBLY AND OPERATION
This kit is intended for use on Champion Power Equipment 2000
Watt Inverter Generators. Please refer to your Inverter Owner’s
Manual for safety rules, start up and shut down procedures,
specifications and troubleshooting.
Setup and Operation
ASSEMBLY AND OPERATION
A
C
B
6. Plug the other pair of power leads (B), communication
cable (A), and ground wire (C) to inverter #2.
7. Align pins of the communication cable when connecting
(A).
1. The two generators may be stacked one on top of the
other by aligning the lower pads and upper pockets at each
corner of the generators.
8. Start engines of both inverters according to your Inverter
Operator’s Manual. Observe the green output indicator light
on both generator panels – The light will blink during start
up. When the light is steady you may connect devices.
9. Connect devices to parallel panel or generator panel
receptacles. Loads up to 25 amps may be connected to
the parallel kit receptacles. Individual loads connected
to generator panels must be less than the 20 amp panel
receptacle rating.
10. The total electrical load must not exceed 30 amps (3600
watts).
11. Follow the instructions in your Inverter Owner’s Manual for
turning off the generators.
2. Disconnect or turn off all electrical loads from both
generators.
3. The economy switch must be in the same position on both
generators.
4. Remove caps from the power leads
5. Plug one pair of power leads (B), communication cable (A),
and ground wire (C) to inverter #1.
12. Pull “sleeve” of communication cable to disconnect.
2
73500I - PARALLEL OPERATION KIT
Parts Diagram
ASSEMBLY AND OPERATION
1
8 9 10
7
2
3
4
5 6
8 9 10
3
73500I - PARALLEL OPERATION KIT
Parts List
# Part Number Description Qty.
1 81.210003.00
2 81.213001.01 Control Box 1
3 1.9074.4.0414.1
4 81.21310 0.0 0.2 Control Panel 1
5 5.1120.023
6 1.6177.1.04.1
7 5.1120.034 Receptacle TT-30R 1
8 5.1900.053
9 5.1900.054
10 5.1130.000 Receptacle 2
Plug, Wire
Screw/Washer
Assembly M4×14,
Black
Receptacle L5-30R,
CSA
Lock Nut M4, Flange,
Black
Plug, Parallel, Wire
250 mm, Black
Plug, Parallel, Wire
280 mm, Black
ASSEMBLY AND OPERATION
2
4
1
4
2
2
4
73500I - PARALLEL OPERATION KIT
Wiring Diagram
TT-30R
ASSEMBLY AND OPERATION
W
G
G/Y
B
G
B W
B
1
R
BLACK BLACK
4
3
G
2
Y
G
1
Y
W
B
B
B
R
4
3
2
L5-30R
W
BLACK BLACK
G
GREEN YELLOW
BLACK
B
G/Y
GREEN
R RED
Y YELLOW
G
5
WARRANTY*
CHAMPION POWER EQUIPMENT
1 YEAR LIMITED WARRANTY
Warranty Qualifications
To register your product for warranty and FREE lifetime call center
technical support please visit:
https://www.championpowerequipment.com/register
To complete registration you will need to include a copy of the
purchase receipt as proof of original purchase. Proof of purchase
is required for warranty service. Please register within ten (10)
days from date of purchase.
Repair/Replacement Warranty
CPE warrants to the original purchaser that the mechanical and
electrical components will be free of defects in material and
workmanship for a period of one year (parts and labor) from
the original date of purchase and 90 days (parts and labor) for
commercial and industrial use. Transportation charges on product
submitted for repair or replacement under this warranty are the
sole responsibility of the purchaser. This warranty only applies to
the original purchaser and is not transferable.
Do Not Return The Unit To The Place Of
Purchase
Contact CPE’s Technical Service and CPE will troubleshoot any
issue via phone or e-mail. If the problem is not corrected by
this method, CPE will, at its option, authorize evaluation, repair
or replacement of the defective part or component at a CPE
Service Center. CPE will provide you with a case number for
warranty service. Please keep it for future reference. Repairs or
replacements without prior authorization, or at an unauthorized
repair facility, will not be covered by this warranty.
Warranty Exclusions
This warranty does not cover the following repairs and equipment:
Normal Wear
Products with mechanical and electrical components need
periodic parts and service to perform well. This warranty does not
cover repair when normal use has exhausted the life of a part or
the equipment as a whole.
Installation, Use and Maintenance
This warranty will not apply to parts and/or labor if the product is
deemed to have been misused, neglected, involved in an accident,
abused, loaded beyond the product’s limits, modified, installed
improperly or connected incorrectly to any electrical component.
Normal maintenance is not covered by this warranty and is not
required to be performed at a facility or by a person authorized by
CPE.
Other Exclusions
This warranty excludes:
– Cosmetic defects such as paint, decals, etc.
– Wear items such as filter elements, o-rings, etc.
– Accessory parts such as starting batteries, and storage
covers.
– Failures due to acts of God and other force majeure events
beyond the manufacturer’s control.
– Problems caused by parts that are not original Champion
Power Equipment parts.
Limits of Implied Warranty and
Consequential Damage
Champion Power Equipment disclaims any obligation to cover
any loss of time, use of this product, freight, or any incidental
or consequential claim by anyone from using this product. THIS
WARRANTY IS IN LIEU OF ALL OTHER WARRANTIES, EXPRESS
OR IMPLIED, INCLUDING WARRANTIES OF MERCHANTABILITY OR
FITNESS FOR A PARTICULAR PURPOSE.
A unit provided as an exchange will be subject to the warranty
of the original unit. The length of the warranty governing the
exchanged unit will remain calculated by reference to the purchase
date of the original unit.
This warranty gives you certain legal rights which may change
from state to state or province to province. Your state or province
may also have other rights you may be entitled to that are not
listed within this warranty.
Contact Information
Address
Champion Power Equipment, Inc.
12039 Smith Ave.
Santa Fe Springs, CA 90670 USA
www.championpowerequipment.com
Customer Service
Mon – Fri 8:30 AM – 5:00 PM (PST/PDT)
Toll Free: 1-877-338-0999
info@championpowerequipment.com
Fax no.: 1-562-236-9429
Technical Service
Mon – Fri 8:30 AM – 5:00 PM (PST/PDT)
Toll Free: 1-877-338-0999
tech@championpowerequipment.com
24/7 Tech Support: 1-562-204-1188
Loading...