Champion Power Equipment 73540i, 73536i, 100148, 73535i, 100489 Technical Bulletin

11/12/18 1 Champion Power Equipment, Inc.

Technical Bulletin

Number: 181107-60-50-1

Date: 11/7/18

Recoil Install for Cube Inverters

This covers the following models (Read completely before performing service):

• 73540i

• 73535i

• 73536i

• 100489

• 100148

• 100455

1. Unscrew the 4 bolts holding the handle and

remove the handle assembly.

2. Unscrew the fuel tank cap and remove the
upper cover.

Note: After removing the upper cover, re-screw
the fuel tank cap to prevent gasoline from
escaping.

11/12/18 2 Champion Power Equipment, Inc.

3. Remove (4) corner panels.

4. Unscrew the screws to remove the right cover.
Repeat for the left cover.

5. Unscrew the (3) bolts that hold the fuel tank.

11/12/18 3 Champion Power Equipment, Inc.

6. Unscrew all screws & bolts of front cover and rear

cover, and then remove the rear cover assembly.

11/12/18 4 Champion Power Equipment, Inc.

7. Unscrew the screw inside fuel ON/OFF switch.

Loosen the clamp of fuel hose at the carburetor
inlet nozzle to pull out the fuel hose, and then
remove the fuel tank.

8. Pull out some length of rope from the recoil

pulley and secure with a stop-knot at the recoil
cover end. Remove the recoil handle.