Champion Industries DH2000 Instruction Manual
Straight-through to Corner Operation Conversion Instructions
Models DH2000 • MD2000
Temp.
Gauges
Temp.
Gauges
6" [15cm]
Dishwashers are shipped from the factory for Straight-through operation.
Dish racks enter and exit the sides of a straight-through machine.
Dish racks enter the side and exit the front of corner operation machine.
To position the dishwasher:
1. Convert the dishwasher before it is placed in its nal position
and before connecting utilities.
2. The temperature gauges must be clearly visible to the operator
when facing the front of the machine. In addition, the door
handles should move freely without interference from walls or
other obstructions. Nominal wall clearance is 6" [152mm];
the minimum wall clearance is 4" [102mm].
6" [15cm]
Convert track guides and door-lift for corner operation:
1. Remove the rack guide (A). Save the fasteners and re-attach (A)
as shown in the illustration at right.
2. Slide a dish rack through the machine to check the guide to dish
rack clearance. The dish rack should move smoothly without
binding or tipping on the guides.
3. Disconnect the door-lift bracket (B) connecting the front door and
the wall-side door and discard. To seal the holes, reinstall the bolts
and lock washers that held the door-lift bracket.
4. Disconnect the door linkage arm (C) from the wall-side door and
discard. Reinstall the white roller (D) and existing hardware.
5. Disconnect the door linkage arm (C) from the other door but do
not discard. This linkage arm is reattached after spring adjustment.
6. Lift the door handle up and back until the springs relax.
7. Adjust the door springs (E) located at the rear of dishwasher to
reduce the door spring tension until the front and side doors open
and close without binding.
A
wall
wall
A
Form No. 114636_0
B
C
D
E
Loading...