Double skinned stainless steel with
exterior latch and inside release handle.
Rotating Wash Hub & Spray Arm Assembly
Water driven, stainless steel, spray arm
assembly with stainless steel jets, removable
end caps and hand-operated, quick-release
mechanism for easy cleaning and reassembly.
Mounted on stainless steel base.
Filter
Perforated stainless steel screen type.
Double filtration system for increased
effectiveness and easy cleaning without
emptying the tank.
Water Pump
25 H.P., 208/240/480 volt, 3 phase,
60 cycle with output of 430 gallons
per minute at 40 to 50 P.S.I.
Digital Control & Information Center
120 volt control circuit with push pad
operation of “Power On”, “Stop” and “Short,
Medium or Long Wash Cycles”. A digital
display indicates “Time Remaining” for each
cycle. LED’s indicate wash, rinse and
unload functions. A buzzer is also included
to provide an audible indication of time to
unload. A pre-programmed circuit board
allows the push pad to be used as a
“Diagnostic Center” by displaying “Error
Codes” for ease of troubleshooting.
Due to an ongoing value analysis program at Champion, specifications contained in this catalog are subject to change without notice.
2674 N. Service Road, Jordan Station, Ontario, Canada L0R 1S0 • 905/562-4195 • Fax: 905/562-4618
Stainless steel with electric, infrared gas,
live steam or steam coil heating, thermostatically
controlled, low water protected, sloped to
drain with a 160-gallon capacity.
Rinse Tank
Stainless steel, 20 gallon capacity with
208/240 or 480 volt electric booster
heaters. 18 kW total to provide
180°/19°F hot sanitizing rinse.
Racks
Constructed of stainless steel rod and
formed angle, heliarc welded.
Page 3
SPECIFICATIONS
MODEL 2554 RACK, PAN AND
UTENSIL WASHER
WasherA
utomatic washing machine designed to wash and sanitize items commonly used in
the bakery, meat, poultry, candy and food service industries. Machine is designed to
be installed in a pit or used at floor level with a ramping system.
Cabinet64" wide x 80" deep x 94" high. Note: for pass-thru operation, cabinet length is 90".
Clearance height 124". Standard door opening: 32" wide x 76-1/2" high. Wash
chamber: 32" wide x 62" deep x 76-1/2" high. Constructed of 12, 14 & 16 gauge,
type 304 #3 finish, stainless steel. All seams tig-welded. Seams where needed for
water tight construction are continuously welded.
DoorStandard right hand or optional left hand swing constructed of 14 and 16 gauge, type
304 #3, stainless steel with integral stainless steel framework. Door double skinned
for added strength. Equipped with door latch and inside release handle. Door is
interlocked with limit switch to prevent machine operation while open.
Washer FloorFloor constructed of 12 gauge stainless steel formed sheets designed to provide
maximum strength. Floor supports constructed of 2" x 2" x 1/4" stainless steel angle.
Recirculating Wash TankHeated by 24 kW 208/240 or 480 volt electric immersion heaters, thermostatically
controlled wash temperature and low water protection system. 160 gallons (140
gallons if infrared gas heated), 14 gauge stainless steel, sloped to drain. Infrared gas
and steam coil heating options available.
Wash Tank FilterPerforated, stainless steel baskets. Designed for increased effectiveness and easy
cleaning without emptying wash tank.
Wash Tank Fill ValveSize 3/4" brass material, solenoid type, automatic operation.
Drain ValveSize 2" brass material, gate type for manual or electrically operated ball valve for
automatic option.
Wash Pump25 H.P., 208/240 or 480 volt, 3 phase, 60 cycle. Close coupled; 430 gallons per
minute at 35 to 45 psi, mounted on 12 gauge stainless steel formed channel base.
Rotating Wash Hub &Water driven, stainless steel spray arm assembly with stainless steel jets, removable
Spray Arm Assemblyend caps and hand-operated, quick-release mechanism for easy cleaning and
reassembly. Mounted on stainless steel base.
Sanitizing Rinse TankStainless steel, 20 gallon capacity, with electric, infrared gas or steam coil heating to
provide 180°/190° F hot sanitizing rinse. Uses 16 gallons per 30 second cycle.
Optional SanitizingStainless steel, 60 gallon capacity, supplied with 3/4 H.P. pump to provide 16 gallons per
Pumped Rinse Tank30 second cycle at 20 psi. Thermostatically controlled, low water protected with
automatic fill to provide 180°/190°F hot sanitizing rinse. Available in electric, infrared
gas or steam coil heating.
Final Rinse PipingType 304 stainless steel tubing with brass compression fittings and brass or optional
stainless steel full cone rinse jets.
Control &120 volt control circuit with push pad operation of “Power On,” “Stop” and “Short,
Information CenterMedium or Long Wash Cycles.” A digital display indicates “Time Remaining” for each
cycle. LED’s indicated wash, rinse and unload functions. A buzzer is also included to
provide an audible indication when the machine is ready to unload. A pre-programmed
circuit board allows the push pad to be used as a “Diagnostic Center” by displaying
“Error Codes” for ease of troubleshooting. Moisture resistant gauges measure wash
temperatures, wash pressure and rinse temperature.
2674 N. Service Road,
Jordan Station, Ontario, Canada L0R 1S0
Tel: 905/562-4195Fax: 905/562-4618
(1M) 10/06Printed in U.S.A.
Champion Industries, Inc.
P. O. Box 4149, Winston-Salem, NC 27115
Tel: 336/661/1556Fax: 336/661-1979
www.championindustries.com
Page 4
SPECIFICATIONS
MODEL 2554 RACK, PAN AND
UTENSIL WASHER
External Rinse HoseE
xternally mounted rinse hose with spray gun for easy cleaning and maintenance
of machine.
Steam Exhaust VentSteam exhaust vent 12-7/8" I.D., consisting of 14 gauge rolled collar for PVC pipe
connection, bolted to the top of the machine. Machine pre-wired with control timer
for the addition of a fan.
Optional Exhaust Fan12" diameter exhaust fan mounted on washer to extract steam after rinse cycle.
Constructed for moisture laden air or other air stream contaminants. 500 CFM
@ .5" static pressure. 1/4 H.P., 1750 RPM.
Optional Hood & FanStainless steel hood and fan assembly, mounted over door to evacuate steam that
escapes when door is opened. Fan constructed for moisture laden air or other air
stream contaminants. Maximum temperature 160°F, 15" diameter exhaust fan,
2450 CFM, .56" static pressure, 1 H.P., 3450 RPM.
RacksCustomized to hold your specific items. Constructed of stainless steel rod and formed
angle, Heliarc welded. Supplied with stainless steel casters and nylon wheels.