Chamberlain RWA300R User Manual
Overview
®
Model RWA300R
Wireless Pedestrian & Vehicle Alert
The Alert uses a Passive Infra-Red sensor to detect
movement of people and vehicles, while allowing
small animals to pass through undetected.
Carton Inventory
Swivel Bushing
Base Station
Sun/Rain Shield
Passive Infra-Red (PIR)
Motion Sensor
Mounting Plate
Rubber Pads
AC Adapter
Operation & Features
To prevent possible SERIOUS INJURY or DEATH from
electrocution, outputs are suitable ONLY for controlling low
voltage devices, 24V max, ac or dc.
Battery: The AA batteries (not provided) in the PIR
Motion Sensor will last up to 2 years depending on
use (Lithium batteries recommended for colder
environments). If Base Station battery (optional) is
low, it will beep every few minutes. Replace with
9-Volt battery (not provided). For peak performance
inspect batteries annually and replace as needed.
Base Station Switches:
Switch #1:
OFF Buzzer Off
ON Buzzer On (Default)
Switch #2:
2
1
OFF Long Buzz
ON Short Buzz (Default)
OFF
ON
Base Station
Mute/Off
Button
Antenna
AC Adapter
Learn Button
Base Station Switch #1
Base Station Switch #2
On/Off: To turn Base Station off hold down the Mute
Button until it powers down. The Base Station can be
turned on by pressing the Mute Button.
Mute: Press and release the Mute Button to put the
Base Station into Sleep Mode for one hour. After an
hour it will activate automatically.
Relay Output
Contacts
Programming Additional PIR Motion Sensors: The
Base Station can learn the code of up to 3 additional
PIR Motion Sensors, responding with unique buzzes.
To program additional PIR Motion Sensors see
Step 6.
To order additional PIR Motion Sensors call
1-800-528-9131.
Clear Memory: Press and hold the Learn Button on
the Base Station until 3 beeps are heard.
1
PIR Motion Sensor Assembly & Test
Step 1
Attach PIR Motion Sensor box to mounting plate with
large silver screw. Tighten screw until PIR Motion
Sensor stays in place when repositioned.
Step 2
Step 3
Insert battery pack facing away from circuit board and
attach cover.
NOTE: Ensure the batteries do not touch the circuit
board and the antenna and battery wires are not
pinched.
Step 4
Install 4 AA Alkaline batteries (not provided). (Lithium
batteries recommended for colder environments.)
Test light will flash.
Switch Settings
Antenna
Switch #1:.
OFF 15' Detection Range
ON 30' Detection Range
(Default)
Switch #2:
OFF Low Sensitivity
ON High Sensitivity
(Default)
PIR Sensor
Test
Button
Switch #1
Switch #2
OFF
2
1
ON
Test PIR Motion Sensor by waving hand in front of
sensor. Test light should flash. Secure cover with the
smallest screws.
NOTE: To avoid unwanted detection of small animals
move Switch #2 to OFF.
2
Loading...