Chamberlain DH, DHJ, DJ, LiftMaster DH, LiftMaster DHJ Addendum

...
APPLICATION REQUIREMENTS
WARNING WARNING
WARNING
This modification is available to models H and J Logic operators.
ADDENDUM
LOCK SENSOR
Models DH, DJ, and DHJ
FUNCTIONS
This modification stops the operator from running when extra tension is sensed on the door from the mechanical door lock, obstruction, or extensive binding.
When the lock sensor senses an excessive load while running the open cycle from the close limit, the lock sensor will stop the operator. Press the close button and run the operator until it shuts off (to unlock the door when the load is removed).
NOTE: Refer to lock sensor addendum for adjustment. For all other installation instructions refer to owner’s manual provided with operator.
LOCK SENSOR ADJUSTMENT
FINE ADJUSTMENT
• To increase opening force, tighten the wing nut.
• To decrease opening force, loosen the wing nut.
COURSE ADJUSTMENT (IF REQUIRED)
1. Release spring pressure on pivot arm.
2. Loosen but do not remove two mounting screws.
3. Fully tension final reduction chain and rotate lock sensor until switch is in activation mode.
4. Tighten mounting screws (2) to secure lock sensor position.
5. Repeat fine adjustments.
Moving parts may cause SERIOUS INJURY. Keep hands CLEAR of sprockets, chains, and other moving parts when making adjustments.
Chain Idler Sprocket
Final Reduction Chain
Final Reduction Chain
© 2010, The Chamberlain Group, Inc. 01-31376C All Rights Reserved
Chain Idler Sprocket
must engage top side
must engage top side
of reduction chain.
of reduction chain.
Mounting Screws
Mounting Screws
Lock Sensor Assembly
Lock Sensor Assembly
Lock Sensor Switch
Lock Sensor Switch
(held to normally closed).
(held to normally closed).
To adjust opening force
To adjust opening force tighten
tighten or loosen adjustment
or loosen adjustment on wing nut
on wing nut accordingly.
accordingly.
Loading...