Chad Valley 367/3568 User guide

Single Swing

Assembly & User Instructions -

Please keep for future reference

367/3568

Important

Age: 3 - 8 years
Maximum user

weight: 45kg

Important -

These instructions contain important information which will help you get the best from your
product and ensure safe and correct assembly, use and maintenance.

If you need he

lp or have damaged or missing parts, call the

Tips: It will take 2 adults
around 30 minutes to
assemble.

Please read these instructions fully before assembly or use.

Customer Helpline: ([phone]

Contents

Warnings

Parts

Assembly Instructions

Care and Maintenance

2

3

4-8

9

1

Warnings

Important –Please read these instructions fully before assembly or use.

●

Packaging materials are not toys. Please remove all

WARNING

●

WARNING! Not suitable for children under the age of

36 months because of sma ll part(s) and long cord(s)

– choking and entanglement/ strangulation hazards.

●

Suitable for children aged 3-8 years.

●

Only one child per seat at any one time.

●

For outdoor use.

●

Check all nuts, bolts and fittings for tightness and tighten if

required.

●

Check all coverings for bolts and sharp edges and replace

when required.

●

Oil all metallic moving parts.

●

Check swing seats, ropes and other means of attachments

for evidence of deterioration. Replace when required in

accordance with the manufacture’s instructions.

●

Please take note: As an extra precaution, check this toy

regularly for signs of wear and damage.

●

Place the product on a level surface at least 2 meters from

any structures or obstructions such as a fence, garage,

house, overhanging branches, laundry line or electrical

wires.

●

For safety reasons, this swing MUST be anchored into the

ground.

●

Anchors

order to reduce the risk of tripping. Ensure the child is not

facing the sun when on the swing.

●

Leave all fittings finger-tight until assembly is complete, for

ease of construction. Then tighten firmly.

●

This item is not for adults or children weighing more than

45kg.

●

DO NOT install the product on concrete, asphalt or hard

surfaces.

●

DO NOT allow children to stand on the swing seats.

●

DO NOT allow children to get off the swings while they are

still moving.

●

DO NOT twist swing ropes or wrap them over the top bar.

●

DO NOT allow loose, hooded or baggy clothes to be worn

since children can get trapped and may be unable to free

themselves.

●

DO NOT allow children to climb on this equipment.

●

DO NOT allow children to wander into the play area when

the equipment is in use.

●

Swings must not exceed an angle of 60 degrees from the

ground.

●

Failure to assemble and maintain this item as per these

instructions may cause injury to the user.

shall be placed level with or under the ground in

packaging and packing tags / wires before giving this

toy to your child.

●

Adult assembly required.

●

For use under adult supervision.

●

Check and maintenance of the main parts(crossbeams,

suspensions,

checks are not carried out, the toy could overturn or

otherwise become a hazard.

●

Changes to the original toy (for example the adding

of an accessory) shall be carried out according to the

instructions of the original toy manufacturer.

●

Mai n t enanc e to be c arr i ed out under t h e direc t

supervision of responsible adult.

●

For family domestic use only.

●

Once assembly i s complet e, caref ully check t he

equipment before use. If you find any problems, do not

allow children to use the equipment until it is fit for use.

●

Do not adjust the length of the swing rope.

●

Please retain these instructions for future reference.

●

Warning! Only for domestic use.

anchors, ELC.)at regular intervals. If these

2

If you have damaged or missing parts,

Parts

call the Customer Helpline:

Please Check you have all the parts fittings listed below

1

Beamx1pc

2

Legx2pcs

3

Legx2pcs

5

Railx2pcs

6

Seatx1pc

Anchorx4pcs

7

([phone]

A

(M8)

2

×

E

( Ø14×Ø6.5mm)

16

×

J

(M6)

8

×

4

Legx4pcs

B

x4(M6x42mm)

G H

(

3.5

Ø1

4

×

×Ø8.5mm

)

Z

1 (4 mm)

×

C

x4(M6x53mm)

(

Ø10×Ø6.5mm

8

×

W

1(10 & 13 mm)

×

Plastic Cap x 4pcs

8

D

8

×

I

)

×

( Ø19×Ø8.5mm )

(M8)

4

Important -

3

Please read these instructions fully before assembly or use.

Assembly Instructions

1

2

3

D

G

I

A

D

Step 1

Insert Leg(2) and Leg (3) into
beam(1) as shown in Figure 1.
Attach the swing seat (6) to beam
(1) using U bolt(A).

Note the position of the
Legs need to be inversed
on the two sides of the
swing frame.

X 2

1

2

3

3

2

6

4

A

x 2pcsDx 8pcsGx 4pcsIx 4pcs

Figure 1

Assembly Instructions

4

8

5

H

J

E

B

E

Step 2

Insert Legs (4) into legs (2) and (3)
and secure together with Rail (5) as
shown in figure 2.

Note:

-Plastic cap (8) needs to
be inserted into rail (5)
before securing the bolt.

-Rail (5) needs to be
attached to the outer
sides of the swing frame.

1

2

3

2

5

4

4

6

4

3

5

4

X 4

B

x 4pcsEx 8pc sHx 4pcsJx 4pcs

Figure 2

5

Assembly Instructions

J

E

C

E

H

4

7

Step 3

Attach anchors (7) to the base of
Legs (4). Repeat this step for the
other remainder anchors.

TIP: AFTER FINISHING
ALL STEPS ABOVE,
GO OVER THE ENTIRE
UNIT AND TIGHTEN ALL
BOLTS.

4 4

7

4

7

7

7

X 4

C

x 4pcsEx 8pcsHx 4pcsJx 4pcs

6

Figure 3

Assembly Instructions

Step 4

Anchor the swing in the ground.

By following the previous steps,
your single swing should look as

shown in the figure 4.

x4

7

6-8CM

Figure 4

7

Assembly Instructions

SEAT ADJUSTABLE GUIDE

THE LENGTH OF THE ROPE IS ADJUSTABLE FOR THE HEIGHT OF THE CHILD
THROUGH THE SEAT CONNECTOR.

TO ADJUST, LOOSEN THE KNOT ON THE SEAT CONNECTOR, PULL ROPE
THROUGH THE HOLES AND TIGHTEN AGAIN.

MAKE SURE THAT THE KNOTS ARE TIGHT AND THAT BOTH ROPES ARE
ADJUSTED SO THAT THE SEAT IS HORIZONTAL.

IMPORTANT: MINIMUM CLEARANCE BETWEEN THE FOOTREST/SEAT
AND THE GROUND SHOULD BE 35 CM.

8

Care and Maintenance

General

Th i s Si n g l e Sw i n g wa s desi g ne d and
man ufactured with quality materials and
craftsmanship.

Inspect regularly for:

•

C H E C K A L L N U T S A N D B OL T S T W IC E
MONTHLY DURING THE USAGE SEASON FOR
TIGHTN E S S AND TIGHTE N AS REQUIRED.
IT IS PARTICULARLY IMPORTANT THAT THIS
PROCEDURE BE FOLLOWED AT THE BEGINNING
OF EACH SEASON.

•

Never use pliers or power tools to tighten up screws

- these can cause damage to both the paintwork and
the special anti - corrosion plating.

•

Tighten all nuts and bolts securely. Replace as

needed. If not checked regularly, bolts can be loose
or missed and components can become detached and
cause injuries.

•

Check the unit at the beginning of the usage season
and monthly thereafter for evidence of deterioration.

•

Immediately remove and replace any items that
appear to be weak or broken. Contact Customer

•

Check all covers designed for bolts and sharp edges
regularly to be certain they are present and in good
condition. Replace as needed.

important that all covers are checked prior to the first

use each season.

•

Inspect handle bar, hardware, and etc., for proper
closure and for signs of wear, deterioration, rust and/
or damage. Replace as needed.

•

Lubricat e al l me t allic mo v i n g pa r ts m o n t h l y
during the usage season. Applying a light coat of
automobile wax to all metal tubing surfaces will help
protect your unit and add to its longevity. Sand any
rusted areas of the metal tubing and repaint using a
non-lead based paint.

•

Remove plastic seats and store indoors, and do not
use when the temperature drops below 32°F/0°C.

•

Check unit for scuffs, burrs, sharp edges and any
other defects that may occur from assembly, abuse,
shipping or everyday use. Burrs and sharp edges
may be filed down until smooth and covered with
duct tape if necessary.

It is particularly

If correct care and maintenance is taken, it will
provide users with longer usage for exercise,
fun and enjoyment.

To help main t a i n t he product’ s appear a n c e ,

•
occasionally clean the seats and metal framework
wi th a dam p cloth lightl y – but DO N OT use
abrasive chemical cleaners.
When the time comes to disassemble and dispose

•
of this product, please completely disassemble the

unit and discard of it in a safe place and manner
so as not to present any hazard to any individual. It

is important to check and maintain the main parts
at regular intervals.If these checks are not carried
out,the toy could overturn or otherwise become a
hazard.Whenever practical,the instructions shall
also be affixed to the toy.

IMPORTANT!KEEP FOR FUTURE REFERENCE.

•

WARNING!

Not suitable for children under the age of
36 months because of small part(s) and
long cord (s) - choking and entanglement/
strangulation hazards. Suitable for children
aged 3-8 years. Only one child per seat at
any one time.For family domestic use only.
Suitable for outdoor use. This item is not for
adults or children weighting more than 45kg.
Adult assembly required. It is important that
children be supervised at all times. Do not
leave children unattended. Packaging
materials are not toys. Please remove all
packaging and packing tags/wires before
giving this toy to your child.

WA R N ING ! No t s uit a b le fo r
children under 3 years due to
small parts, chocking hazard.

([phone]:enilpleH remotsuC eht llac,strap gnissim ro degamad evah ro pleh deen uoy fI

Produced for Chad Valley Toys. Argos Ltd. Country of origin: China
Address: 489 - 499 Avebury Boulevard, Central Milton Keynes, MK9 2NW. www.argos.co.uk

9

SP-6-SW001-ARGOS-18001