CFM Corporation ICVCEFP01 User Manual
C US
Inspire Electric Fireplace
Model: ICVCEFP01
Trim Models: ICVCTK01 Black, ICVCTK02 Pewter,
ICVCTK06 Ebony Black w/Brushed Nickel Accent,
ICVCTK07 Burnished Black
IMPORTANT SAFETY INFORMATION
ALWAYS READ THIS MANUAL FIRST BEFORE
ATTEMPTING TO INSTALL OR USE THIS FIREPLACE
ALWAYS COMPLY WITH ALL WARNINGS AND SAFETY
INSTRUCTIONS CONTAINED IN THIS MANUAL, TO
PREVENT PERSONAL INJURY OR PROPERTY DAMAGE
FOR YOUR SAFETY
Always use a qualified technician or service agency to
repair this fireplace
NEVER STORE OR USE GASOLINE OR OTHER VOLATILE
SUBSTANCES IN THE VICINITY OF THIS OR ANY OTHER
HEATING APPLIANCE
INSTALLER: Leave this manual with the appliance.
CONSUMER: Retain this manual for future reference.
10009472 8/07 Rev. 3
Inspire Electric Fireplace
Thank you and congratulations on your purchase of a CFM Corporation electric fireplace.
IMPORTANT: Read all instructions and warnings carefully before starting installation. Failure to
follow these instructions may result in a possible electric shock, fire hazard and will void the warranty.
PLEASE READ THE INSTALLATION & OPERATING INSTRUCTIONS
BEFORE USING THIS APPLIANCE
Table of Contents
Installation Instructions
General ........................................................................................3
Locating your fireplace ................................................................3
Clearance to combustibles .......................................................... 3
Fireplace dimensions ................................................................... 4
Electrical specifications ...............................................................4
Electrical connection .................................................................... 4
Grounding instructions ................................................................. 4
Direct (Hard) Wiring Electric Fireplace ........................................ 5
Fireplace Assembly
Unpack the appliance .................................................................. 6
Carton contents ........................................................................... 6
Appliance mounting ..................................................................... 6
Heater assembly .......................................................................... 6
Trim assembly ............................................................................. 6
Operating Instructions
Heater operation .......................................................................... 8
Frequency setting information ..................................................... 8
Maintenance
Light bulb replacement ................................................................ 9
Glass Information ........................................................................9
Care and cleaning .......................................................................9
Service ......................................................................................... 9
Replacement Parts ............................................................................... 10
Warranty ................................................................................................ 11
Thank you and congratulations on your purchase of a CFM Corporation electric fireplace.
IMPORTANT: Read all instructions and warnings carefully before starting installation. Failure to fol
low these instructions may result in a possible electric shock, fire hazard and will void the war
ranty.
-
Always read the warnings and operating instructions first, before attempting to install or use this fireplace, to prevent personal injury, property dam
age or voiding of the warranty.
2
10009472
-
-
Installation Instructions
General
1. Read all instructions before using this appliance.
2. This appliance is hot when in use. To avoid burns, do not
let bare skin touch hot surfaces. If provided, use handles
when moving this appliance. Keep combustible materials,
such as furniture, pillows, bedding, papers, clothes and
curtains away at least 3’ (914 mm) from the front of this
appliance.
3. CAUTION: Extreme caution is necessary
when any heater is used by or near children or
invalids and whenever the heater is left operating unattended.
4. If possible, always unplug this appliance when not in use.
5. Do not operate any heater with a damaged cord or plug
or after the appliance malfunctions, has been dropped or
damaged in any manner.
6. Any repairs to this appliance should be carried out by a
qualified service person.
7. Under no circumstances should this appliance be modified. Parts having to be removed for servicing must be
replaced prior to operating this fireplace again.
8. Do not use outdoors.
9. This heater is not intended for use in bathrooms, laundry areas and similar indoor locations. Never locate this
appliance where it may fall into a bathtub or other water
container.
10. Do not run cord under carpeting. Do not cover cord with
throw rugs, runners or the like. Arrange cord away from
traffic areas and where it will not be tripped over.
11. To disconnect this appliance, turn controls to the off position, then remove plug from outlet.
Inspire Electric Fireplace
12. Connect to properly grounded outlets only.
13. This appliance, when installed must be electrically
grounded in accordance with local codes, with the current
CSA C22.1 Canadian Electrical codes or for US installations, follow local codes and the National Electric Code,
ANSI/NFPA No. 70.
14. Do not insert or allow foreign objects to enter any ventilation or exhaust opening as this may cause an electric
shock, fire or damage the appliance.
15. To prevent possible fire, do not block air intakes or ex
haust in any manner. Do not use on soft surfaces, like a
bed, where openings may become blocked.
16. This appliance has hot and arcing or sparking parts inside.
Do not use it in areas where gasoline, paint or flammable
liquids are used or stored. This appliance should not be
used as a drying rack for clothing, nor should Christmas
stockings or decorations be hung on or near it.
17. Use this appliance only as described in this manual. Any
other use not recommended by the manufacturer may
cause fire, electric shock or injury to persons.
18. Avoid the use of an extension cord because of the risk of
overheating the cord and the risk of fire. Extension cords
are for temporary use only. If an extension cord must be
used, it must be UL/CSA certified, rated at 15A (1875W),
125 V maximum with 14 AWG minimum and constructed
of two current carrying conductors with ground. A heavy
duty extension cord with the shortest length possible for
this connection is recommended and must not be longer
than 50 ft. (15.2 m). Do not coil or cover the extension
cord.
Locating Your Fireplace
When choosing a location for your new fireplace, ensure the general instructions are followed. Also, for best
effect, install the fireplace out of direct sunlight.
-
10009472
Clearance to Combustibles
Sides (including trim assembly) ........... 0” (0 mm)
Bottom ........................................... 9⁷⁄₈” (250 mm)
Top ....................................................3’ (914 mm)
SAVE THESE
INSTRUCTIONS
3
Inspire Electric Fireplace
A
B
C
35” (910 mm)
24
”
(615 mm )
9”
(250 mm)
5”
(145 mm)
36”
(914 mm)
[Heater Main Body Width 32” (832 mm)]
23"
(594 mm)
Fireplace Dimensions
Minimum Shelf Height
(To Heater Main body)
Minimum
From Floor
Electrical Specifications
Voltage 120V ac, 60 Hz
Total Amps 7.9 Amps
Total Watts 1050W
Heater Rating 2 x 500W
Illumination 2 x 20W Low Energy Bulb
Electrical Connection
A 15 amp, 120 Volt, 60 Hz circuit with a properly
grounded outlet is required. Preferably, the fireplace
will be on a dedicated circuit as other appliances on the
same circuit may cause the circuit breaker to trip or the
fuse to blow when the heater is in operation. The unit
comes standard with a 6 ft. (1.8 m) long three wire cord,
exiting the left side of the fireplace. Plan the installation to avoid the use of an extension cord. Extension
cords are for temporary use only. If an extension cord
must be used, it must be UL/CSA certified, rated at 15A
(1875W), 125V maximum with 14 AWG minimum and
constructed of two current carrying conductors with
ground. A heavy duty extension cord with the shortest
length possible for the connection is recommended and
must not be longer than 50 ft. (15.2 m). Do not coil or
cover the extension cord.
place until it has first been inspected if any portion
of it has been exposed to water. Always utilize a
qualified service technician to inspect the fireplace
and to replace any electrical system components
that may have been damaged by water.
Grounding Instructions
This heater is for use on 120 volts. The cord has a plug
as shown at A in Figure 1. An adapter as shown at C
is available for connecting three-blade grounding-type
plugs to two-slot receptacles. The green grounding lug
extending from the adapter must be connected to a permanent ground such as a properly grounded outlet box.
The adapter should not be used if a three-slot grounded
receptacle is available.
Cover of
Grounding Pin
Grounded
Outlet Box
WARNING
Always confirm that the electrical outlet wiring is
in compliance with all applicable local and national
building codes and electrical code requirements to
avoid the risk of fire or electric shock.
If the fireplace should be exposed to water, immediately turn off the main power supply and remove
the power plug from the outlet. Never use the fire-
4
Adapter
Fig. 1 Grounding methods.
Grounding Means
Metal Screw
FP1636
10009472
Loading...