Cerno CXL10367 Installation & Assembly

Calx 10
Installation Instructions
General Product information
This product is suitable for indoor dry and damp locations only.
CAUTION - RISK OF FIRE
This product requires installation by a qualied electrician. Before installing be sure to read all instructions and TURN POWER OFF TO THE JUNCTION BOX
Typical 3” Plaster Ring
Adjusting the Fixture Height
Measure the desired height (H) that
1
you want the xture to hang below the ceiling.
Red (+)
White (+)
Black (-)
Black (-)
Knot
Washer
Crossbar
Canopy
Shade
LED Driver
110V AC Electrical Service
White (NEUTRAL)
White (NEUTRAL)
Black (HOT)
Black (HOT)
8-32 Screw
Thumb Nut
Yellow
Wire Nuts
2
Thread the cable through the top diuser, shade, thumb nut, canopy, crossbar assembly, and washer. (See Figure 2)
3
Tie a knot in the cable at the desired length H.
1
H
Making Electrical Connections
4
Make electrical connections as shown in gure 2 using the supplied wire nuts.
Top
Diuser
THE LED DRIVER IS A DC DEVICE AND MUST BE ATTACHED TO THE LED LIGHT ENGINE AS SHOWN. CONNECTING THIS
LED Light
Engine
CERNOGROUP.COM T_949.715.1534 1751 MCGAW AVE, IRVINE, CA 92614 COPYRIGHT 2016 CERNO LLC. ISSUE DATE 2/1/2017
DEVICE INCORRECTLY WILL CAUSE SEVERE DAMAGE.
WARNING
Calx 10
Installation Instructions
Mounting the Fixture
Attach the crossbar to the junction box using the
5
supplied 8-32 screws.
Securing the Canopy
After electrical connections have been made, place LED driver and
6
all of the wires inside of the junction box.
7
Slide the canopy up the cable and secure it by screwing the thumb nut onto the crossbar.
CERNOGROUP.COM T_949.715.1534 1751 MCGAW AVE, IRVINE, CA 92614 COPYRIGHT 2016 CERNO LLC. ISSUE DATE 2/1/2017
Loading...