
1. Product and company identification
0354567 v3.0
8002505 v1.0
8082311 v1.0
0330875 v1.0
Cepacol Extra Strength Throat Lozenges - Cherry
Emergency telephone
number (Medical)
Emergency telephone
number (Transport)
1-800-424-9300 (U.S. & Canada) CHEMTREC
Outside U.S. and Canada (North America), call Chemtrec:703-527-3887
This SDS is designed for workplace employees, emergency personnel and for other conditions and situations
where there is greater potential for large-scale or prolonged exposure, in accordance with the requirements of
USDOL Occupational Safety and Health Administration.
This SDS is not applicable for consumer use of our products. For consumer use, all precautionary and first aid
language is provided on the product label in accordance with the applicable government regulations, and shown
in Section 15 of this SDS.
Reckitt Benckiser LLC.
Morris Corporate Center IV
399 Interpace Parkway (P.O. Box 225)
Parsippany, New Jersey 07054-0225
+1 973 404 2600
Conforms to USDOL OSHA 29CFR 1910.1200 HAZCOM
2. Hazards identification
Classification of the
substance or mixture
No known significant effects or critical hazards.
Read label before use. Keep out of reach of children. If medical advice is needed,
have product container or label at hand.
Cepacol Extra Strength Throat Lozenges - Cherry
:

Conforms to USDOL OSHA 29CFR 1910.1200 HAZCOM
2. Hazards identification
Supplemental label
elements
Hazards not otherwise
classified
3. Composition/information on ingredients
There are no additional ingredients present which, within the current knowledge of the supplier and in the
concentrations applicable, are classified as hazardous to health or the environment and hence require reporting
in this section.
Any concentration shown as a range is to protect confidentiality or is due to batch variation.
Wash out mouth with water. Get medical attention if adverse health effects persist or
are severe. Do not induce vomiting. If affected person is conscious, give plenty of water
to drink.
In case of contact with eyes, rinse immediately with plenty of water. If irritation persists,
get medical attention.
In the event of any complaints or symptoms, avoid further exposure. Rinse skin with
water. Get medical attention if symptoms occur.
In the event of any complaints or symptoms, avoid further exposure. Maintain an open
airway. Get medical attention if adverse health effects persist or are severe.
Protection of first-aiders
No action shall be taken involving any personal risk or without suitable training.
Treat symptomatically. Contact poison treatment specialist immediately if large
quantities have been ingested or inhaled.
Description of necessary first aid measures
Most important symptoms/effects, acute and delayed
No known significant effects or critical hazards.
No known significant effects or critical hazards.
No known significant effects or critical hazards.
No known significant effects or critical hazards.
Over-exposure signs/symptoms
Potential acute health effects
Indication of immediate medical attention and special treatment needed, if necessary

Conforms to USDOL OSHA 29CFR 1910.1200 HAZCOM
See toxicological information (Section 11)
5. Fire-fighting measures
Promptly isolate the scene by removing all persons from the vicinity of the incident if
there is a fire. No action shall be taken involving any personal risk or without suitable
training.
Hazardous thermal
decomposition products
Specific hazards arising
from the chemical
Decomposition products may include the following materials:
carbon dioxide
carbon monoxide
No specific fire or explosion hazard.
Fire-fighters should wear appropriate protective equipment and self-contained breathing
apparatus (SCBA) with a full face-piece operated in positive pressure mode.
Special protective
equipment for fire-fighters
Use an extinguishing agent suitable for the surrounding fire.
Suitable extinguishing
media
Unsuitable extinguishing
media
Special protective actions
for fire-fighters
6. Accidental release measures
Environmental precautions
Personal precautions, protective equipment and emergency procedures
Stop leak if without risk. Move containers from spill area. Prevent entry into sewers,
water courses, basements or confined areas. Vacuum or sweep up material and place
in a designated, labeled waste container. Dispose of via a licensed waste disposal
contractor.
See Section 1 for emergency contact information.
See Section 8 for information on appropriate personal protective equipment.
See section 13 for waste disposal information.
No action shall be taken involving any personal risk or without suitable training.
Evacuate surrounding areas. Keep unnecessary and unprotected personnel from
entering. Do not touch or walk through spilled material. Put on appropriate personal
protective equipment.
Avoid dispersal of spilled material and runoff and contact with soil, waterways, drains
and sewers. Inform the relevant authorities if the product has caused environmental
pollution (sewers, waterways, soil or air).
Stop leak if without risk. Move containers from spill area. Vacuum or sweep up
material and place in a designated, labeled waste container.
Methods and materials for containment and cleaning up
For non-emergency
personnel
If specialised clothing is required to deal with the spillage, take note of any information
in Section 8 on suitable and unsuitable materials. See also the information in "For nonemergency personnel".

Conforms to USDOL OSHA 29CFR 1910.1200 HAZCOM
Conditions for safe storage,
including any
incompatibilities
Store between the following temperatures: 20 to 25°C (68 to 77°F). Store in
accordance with local regulations. Store in original container protected from direct
sunlight in a dry, cool and well-ventilated area, away from incompatible materials (see
Section 10) and food and drink. Keep container tightly closed and sealed until ready for
use. Containers that have been opened must be carefully resealed and kept upright to
prevent leakage. Do not store in unlabeled containers. Use appropriate containment to
avoid environmental contamination.
Put on appropriate personal protective equipment (see Section 8).
Precautions for safe handling
8. Exposure controls/personal protection
None required. However, use of adequate ventilation is good industrial practice.
Chemical-resistant, impervious gloves complying with an approved standard should be
worn at all times when handling chemical products if a risk assessment indicates this is
necessary.
If operating conditions cause high dust concentrations to be produced, use dust goggles.
Personal protective equipment for the body should be selected based on the task being
performed and the risks involved and should be approved by a specialist before
handling this product.
Environmental exposure
controls
Emissions from ventilation or work process equipment should be checked to ensure
they comply with the requirements of environmental protection legislation. In some
cases, fume scrubbers, filters or engineering modifications to the process equipment
will be necessary to reduce emissions to acceptable levels.
Appropriate engineering
controls
Good general ventilation should be sufficient to control worker exposure to airborne
contaminants.
Wash hands, forearms and face thoroughly after handling chemical products, before
eating, smoking and using the lavatory and at the end of the working period.
Appropriate techniques should be used to remove potentially contaminated clothing.
Wash contaminated clothing before reusing. Ensure that eyewash stations and safety
showers are close to the workstation location.
Individual protection measures
Occupational exposure limits
Appropriate footwear and any additional skin protection measures should be selected
based on the task being performed and the risks involved and should be approved by a
specialist before handling this product.
9. Physical and chemical properties
6 to 8.5 [Conc. (% w/w): 100%]

Conforms to USDOL OSHA 29CFR 1910.1200 HAZCOM
9. Physical and chemical properties
Easily soluble in the following materials: cold water and hot water.
Auto-ignition temperature
Partition coefficient: noctanol/water
Flammability (solid, gas)
Lower and upper explosive
(flammable) limits
Decomposition temperature
10. Stability and reactivity
Hazardous decomposition
products
Under normal conditions of storage and use, hazardous decomposition products should
not be produced.
Do not use with other products.
Possibility of hazardous
reactions
Under normal conditions of storage and use, hazardous reactions will not occur.
No specific test data related to reactivity available for this product or its ingredients.
11. Toxicological information
Information on toxicological effects
Specific target organ toxicity (single exposure)

Conforms to USDOL OSHA 29CFR 1910.1200 HAZCOM
11. Toxicological information
Specific target organ toxicity (repeated exposure)
Information on the likely
routes of exposure
No known significant effects or critical hazards.
No known significant effects or critical hazards.
No known significant effects or critical hazards.
No known significant effects or critical hazards.
No known significant effects or critical hazards.
No known significant effects or critical hazards.
No known significant effects or critical hazards.
No known significant effects or critical hazards.
No known significant effects or critical hazards.
No known significant effects or critical hazards.
Symptoms related to the physical, chemical and toxicological characteristics
Potential chronic health effects
Delayed and immediate effects and also chronic effects from short and long term exposure
Numerical measures of toxicity
Potential acute health effects
Potential immediate
effects
Potential delayed effects
Potential immediate
effects
Potential delayed effects

Conforms to USDOL OSHA 29CFR 1910.1200 HAZCOM
11. Toxicological information
12. Ecological information
Bioaccumulative potential
No known significant effects or critical hazards.
Persistence and degradability
Soil/water partition
coefficient (KOC)
13. Disposal considerations
The generation of waste should be avoided or minimized wherever possible. Disposal
of this product, solutions and any by-products should at all times comply with the
requirements of environmental protection and waste disposal legislation and any
regional local authority requirements. Dispose of surplus and non-recyclable products
via a licensed waste disposal contractor. Waste should not be disposed of untreated to
the sewer unless fully compliant with the requirements of all authorities with jurisdiction.
Waste packaging should be recycled. Incineration or landfill should only be considered
when recycling is not feasible. This material and its container must be disposed of in a
safe way. Empty containers or liners may retain some product residues. Avoid
dispersal of spilled material and runoff and contact with soil, waterways, drains and
sewers.
14. Transport information
Not a DOT controlled material (United States). Not a TDG-controlled material. This preparation is not classified as
dangerous according to international transport regulations (ADR/RID, IMDG or ICAO/IATA).
15. Regulatory information
TSCA 8(a) CDR Exempt/Partial exemption
: Not determined
United States inventory (TSCA 8b)
: Not determined.
Clean Air Act Section 112
(b) Hazardous Air
Pollutants (HAPs)
Clean Air Act Section 602
Class I Substances
Clean Air Act Section 602
Class II Substances

Conforms to USDOL OSHA 29CFR 1910.1200 HAZCOM
15. Regulatory information
Keep out of reach of children.
DEA List I Chemicals
(Precursor Chemicals)
DEA List II Chemicals
(Essential Chemicals)
Not listed
The following components are listed: SUCROSE DUST
None of the components are listed.
The following components are listed: PROPYLENE GLYCOL; 1,2-PROPANEDIOL
The following components are listed: .ALPHA.-D-GLUCOPYRANOSIDE, .BETA.-DFRUCTOFURANOSYL; 1,2-PROPANEDIOL
Composition/information on ingredients
Composition/information on ingredients
Hazardous Material
Information System (U.S.A.)
National Fire Protection
Association (U.S.A.)
Caution: HMIS® ratings are based on a 0-4 rating scale, with 0 representing minimal hazards or risks, and 4
representing significant hazards or risks Although HMIS® ratings are not required on MSDSs under 29 CFR 1910.
1200, the preparer may choose to provide them. HMIS® ratings are to be used with a fully implemented HMIS®
program. HMIS® is a registered mark of the National Paint & Coatings Association (NPCA). HMIS® materials may
be purchased exclusively from J. J. Keller (800) 327-6868.
The customer is responsible for determining the PPE code for this material.

Conforms to USDOL OSHA 29CFR 1910.1200 HAZCOM
To the best of our knowledge, the information contained herein is accurate. However, neither the above-named
supplier, nor any of its subsidiaries, assumes any liability whatsoever for the accuracy or completeness of the
information contained herein.
Final determination of suitability of any material is the sole responsibility of the user. All materials may present
unknown hazards and should be used with caution. Although certain hazards are described herein, we cannot
guarantee that these are the only hazards that exist.
Indicates information that has changed from previously issued version.
Reprinted with permission from NFPA 704-2001, Identification of the Hazards of Materials for Emergency
Response Copyright ©1997, National Fire Protection Association, Quincy, MA 02269. This reprinted material is not
the complete and official position of the National Fire Protection Association, on the referenced subject which is
represented only by the standard in its entirety.
Copyright ©2001, National Fire Protection Association, Quincy, MA 02269. This warning system is intended to be
interpreted and applied only by properly trained individuals to identify fire, health and reactivity hazards of
chemicals. The user is referred to certain limited number of chemicals with recommended classifications in NFPA
49 and NFPA 325, which would be used as a guideline only. Whether the chemicals are classified by NFPA or not,
anyone using the 704 systems to classify chemicals does so at their own risk.
Reckitt Benckiser LLC.
Product Safety Department
1 Philips Parkway
Montvale, New Jersey 07646-1810 USA.
FAX: 201-476-7770
RB is a member of the CSPA Product Care Product Stewardship Program.
ATE = Acute Toxicity Estimate
BCF = Bioconcentration Factor
GHS = Globally Harmonized System of Classification and Labelling of Chemicals
IATA = International Air Transport Association
IBC = Intermediate Bulk Container
IMDG = International Maritime Dangerous Goods
LogPow = logarithm of the octanol/water partition coefficient
MARPOL 73/78 = International Convention for the Prevention of Pollution From Ships,
1973 as modified by the Protocol of 1978. ("Marpol" = marine pollution)
UN = United Nations