Century Sedona LifeStyle, Sedona 11-975, PM-1724AD User Manual

Instruction
Manual
English PM-1724AD 2/01
SEDONA STROLLER
Do not use this product until you read and understand these instructions.
SEDONA TRAVEL SYSTEM
DEDICATED TO QUALITY
IMPORTANT INFORMATION
Need Help?
Read and understand stroller instruction manual before
using stroller.
Never leave child unattended.Use with only one (1) child at a time.Do not use accessories other than those provided
by Century.
NOTE: All warnings and instructions apply whether stroller is being used with or without child’s tray attached.
Stroller Use:
Maximum Weight: 40 lbs. (18.2 kg)
Maximum Height: 40 inches (101 cm)
Page:
1 Important Information
2 Warnings
3 Assembly
Opening Stroller
Rear Axle and Wheels
Swivel Locking Tabs
Front Wheel Assembly
Footrest
Rear Support Frame for Canopy
Cup Holder
Tray Shield
5 Stroller Use
Locking Or Unlocking Rear Wheels
Locking Or Unlocking Front Wheel Swivels
Child’s Tray Use
Closing Child’s Tray Slot
Seat Back Positions
Canopy Positions
Securing Child With Harness
7 Car Seat/Stroller Use
Attaching Car Seat
Canopy Positions
Removing Car Seat
10 Folding
11 Maintenance
Cleaning Cup Holder
Cleaning Shield
Cleaning Stroller
Dented Tires
12 Replacement Parts
1
Safety First Checklist
Weight and Height Limits
Table of Contents
Save instruction manual
for future reference.
If you should have any problems with this product, call 1-800-837-4044 from anywhere in the U.S. or Canada or fax at 1-610-286-4555.
Or write us at: Century Products
P.O. Box 100 Elverson, PA. 19520-9974 Attention: Customer Service Department
Please have the following information available. See label on stroller leg.
Model Number:
Manufacture Date:
Date of Purchase:
Failure to follow all warnings and instructions could result in serious injury or death.
• Never leave child unattended, even when sleeping.
- Child may become entangled in harness straps and suffocate.
- Stroller may roll away and crash even with brakes engaged.
• Avoid serious injury from falling or sliding out. Always use seat belt.
• Always be sure stroller is fully set up and fold locks are engaged before using.
• DO NOT pull or carry stroller on stairs or escalators with child in it.
• DO NOT allow child to climb unassisted into stroller, play, hang or pull down on stroller handle as stroller may tip over.
• DO NOT hang or place anything on stroller handle or canopy. Stroller may become unstable and tip over.
• DO NOT jog with stroller. Push stroller at a normal walking speed only. Fast walking, jogging or running can cause loss of control.
• Always be sure child is clear of any moving parts when adjusting stroller.
• DO NOT overload basket. Maximum basket weight is 10 lbs. (4.5 kg). Stroller may become unstable and tip over.
• DO NOT use accessories other than those provided by Century.
WARNINGS
2
To open stroller:
• Stand stroller upright and
pull out on Red Frame Latch while opening.
• Spread handle and rear
legs until both Fold Locks “click” into position.
ASSEMBLY
3
Opening Stroller
WARNING
Prevent a possible choking hazard, discard axle protectors and polybag which contained rear wheel parts.
To attach rear axle and brakes:
• Remove axle protectors from ends of axle and discard.
With stroller laying face down on floor, slide brake lever brackets onto rear legs until they “click” in place.
NOTE: Brake levers must face rear of stroller.
To attach wheels to rear axle:
• Slide Wheel onto end of Axle with brake ribs facing in.
• Push Wheel Retainer onto end of Axle. Make sure large end of Wheel Retainer is towards Wheel. Wheel Retainer should snap into groove on end of Axle.
• Snap wheel Retainer Cap over Wheel Retainer.
• Line up slot in Hub Cap with rib on Wheel and snap
Hub Cap in place.
Rear Axle and Wheels
CAUTION:
• Failure to install retainer cap may cause wheels to come off of stroller.
• After wheel assembly is complete, pull on wheels to check that they are locked into place.
Hub Cap
Retainer
Cap
Wheel
Retainer
Wheel
Axle
Fold
Locks
Red Frame
Latch
To attach front wheel assembly:
• Hold wheel assembly upright.
Tilt stroller slightly back and push wheel assembly onto leg until it locks in place.
Repeat for opposite leg.
CAUTION: Pull on wheel assemblies to check that
they are locked in place.
4
ASSEMBLY continued
Front Wheel Assembly
Footrest
To attach cup holder:
• Snap one end of cup holder over stroller frame above canopy.
• Rotate down to opposite side and snap in place.
Cup Holder
WARNING
• To avoid burns, never put hot liquids in cup holder.
• Avoid possible tipping, DO NOT place more than 3 lbs. (1.4 kg) in cup holder.
To secure rear support frame for canopy:
• Rotate canopy forward until
it stops.
• Check to be sure
Rear Support Frame
is locked in place.
If Rear Support Frame is not
locked, pull
forward until it locks.
Rear Support Frame for Canopy
Tray Shield included with some models.
To attach tray shield:
• Hook “A” Tabs under tray.
• Push “B” Tabs until they
snap onto bottom of tray.
• Push front of shield at “C”
Tabs until they snap onto front of tray.
Tray Shield
A
A
B
B
C
C
To attach footrest:
• Snap footrest onto stroller frame and push up.
• Push footrest against legs, then slide footrest down until it snaps onto Cross Tube.
• Check to be sure tabs on bottom
of footrest are
snapped onto Cross Tube.
Cross Tube
Rear
Support Frame
Swivel Locking Tabs
To attach swivel locking tabs:
• Pull Bellow away from swivel Post on front leg.
• Align grooves on Locking Tab with grooves on Post.
• Slide Locking Tab over Post until it snaps in place.
Repeat for opposite leg.
Tray Shield
Loading...
+ 11 hidden pages