Century PM-1722AC User Manual
Instruction
Manual
English PM-1722AC 2/01
CALYPSO STROLLER
Do not use this product until
you read and understand
these instructions.
CALYPSO TRAVEL SYSTEM
DEDICATED TO QUALITY
IMPORTANT INFORMATION
Need Help?
✔ Read and understand stroller instruction manual before
using stroller.
✔ Never leave child unattended.
✔ Use with only one (1) child at a time.
✔ Do not use accessories other than those provided
by Century.
NOTE: All warnings and instructions apply whether
stroller is being used with or without child’s tray
attached.
Stroller Use:
Maximum Weight: 40 lbs. (18.2 kg)
Maximum Height: 40 inches (101 cm)
Page:
1 Important Information
2 Warnings
3 Assembly
Opening Stroller
Rear Axle and Wheels
Swivel Locking Tabs
Front Wheel Assembly
Footrest
Rear Support Frame for Canopy
Cup Holder
5 Stroller Use
Locking Or Unlocking Rear Wheels
Locking Or Unlocking Front Wheel Swivels
Child’s Tray Use
Closing Child’s Tray Slot
Seat Back Positions
Canopy Positions
Securing Child With Harness
7 Car Seat/Stroller Use
Attaching Car Seat
Canopy Positions
Removing Car Seat
10 Folding
11 Maintenance
Cleaning Cup Holder
Cleaning Stroller
Dented Tires
12 Replacement Parts
1
Safety First Checklist
Weight and Height Limits
Table of Contents
Save instruction manual
for future reference.
If you should have any problems with this product, call
1-800-837-4044 from anywhere in the U.S. or Canada or
fax at 1-610-286-4555.
Or write us at: Century Products
P.O. Box 100
Elverson, PA. 19520-9974
Attention: Customer Service Department
Please have the following information available. See label
on stroller leg.
Model Number:
Manufacture Date:
Date of Purchase:
Failure to follow all warnings and instructions could result in serious injury or
death.
• Never leave child unattended, even when sleeping.
- Child may become entangled in harness straps and suffocate.
- Stroller may roll away and crash even with brakes engaged.
• Avoid serious injury from falling or sliding out. Always use seat belt.
• Always be sure stroller is fully set up and fold locks are engaged before using.
• DO NOT pull or carry stroller on stairs or escalators with child in it.
• DO NOT allow child to climb unassisted into stroller, play, hang or pull down on stroller
handle as stroller may tip over.
• DO NOT hang or place anything on stroller handle or canopy. Stroller may become unstable
and tip over.
• DO NOT jog with stroller. Push stroller at a normal walking speed only. Fast walking, jogging
or running can cause loss of control.
• Always be sure child is clear of any moving parts when adjusting stroller.
• DO NOT overload basket. Maximum basket weight is 10 lbs. (4.5 kg). Stroller may become
unstable and tip over.
• DO NOT use accessories other than those provided by Century.
WARNINGS
2
To open stroller:
• Stand stroller upright and
pull out on Red Frame
Latch while opening.
• Spread handle and rear legs
until both Fold Locks “click”
into position.
ASSEMBLY
3
Opening Stroller
WARNING
Prevent a possible choking hazard, discard
axle protectors and polybag which contained
rear wheel parts.
To attach rear axle and brakes:
• Remove axle protectors from
ends of axle and discard.
• With stroller laying face down
on floor, slide brake lever
brackets onto rear legs until
they “click” in place.
NOTE: Brake levers must face
rear of stroller.
To attach wheels to rear axle:
• Slide Wheel onto end of Axle with brake ribs facing in.
• Push Wheel Retainer onto end of Axle. Make sure large
end of Wheel Retainer is towards Wheel. Wheel Retainer
should snap into groove on end of Axle.
• Snap wheel Retainer Cap over Wheel Retainer.
• Line up slot in Hub Cap with rib on Wheel and snap Hub
Cap in place.
Rear Axle and Wheels
CAUTION:
• Failure to install retainer cap may cause wheels to come
off of stroller.
• After wheel assembly is complete, pull on wheels to check
that they are locked into place.
Fold
Locks
Hub
Cap
Retainer
Cap
Wheel
Retainer
Wheel
Axle
Red Frame
Latch
To attach front wheel assembly:
• Hold wheel assembly upright.
• Tilt stroller slightly back and
push wheel assembly onto
leg until it locks in place.
Repeat for opposite leg.
CAUTION: Pull on wheel assemblies to check that
they are locked in place.
4
ASSEMBLY continued
Front Wheel Assembly
To attach footrest:
• Snap footrest onto
stroller frame and
push up.
• Push footrest against legs,
then slide footrest down
until it snaps onto cross tube.
Footrest
To attach cup holder:
• Snap one end of cup holder
over stroller frame above
canopy.
• Rotate down to opposite
side and snap in place.
Cup Holder
Cross Tube
WARNING
• To avoid burns, never put hot liquids in cup
holder.
• Avoid possible tipping, DO NOT place more
than 3 lbs. (1.4 kg) in cup holder.
To secure rear support frame for canopy:
• Rotate canopy forward until
it stops.
• Check to be sure
Rear Support Frame
is locked in place.
If Rear Support Frame
is not
locked, pull
forward until it locks.
Rear Support Frame for Canopy
Rear
Support Frame
• Check to be sure tabs on
bottom
of footrest are
snapped onto Cross Tube.
Swivel Locking Tabs
To attach swivel locking tabs:
• Pull Bellow away from
swivel Post on front leg.
• Align grooves on Locking
Tab with grooves on Post.
• Slide Locking Tab over
Post until it snaps in
place.
Repeat for opposite leg.
Loading...