Central Pneumatic Air Blow Gun Set 95159, 95159 Owner's Manual

4-PIECE AIR

BLOW GUN SET

Air Blow Gun With Standard Nozzle and

T wo Extensions

Die-cast Aluminum Frame Body; Steel T rigger Level;

Threaded Die-Cast Zinc Tips

Air Inlet: 1/4” - 18 NPT

Air Discharge: 3/32” Diameter

Maximum PSI: 110 PSI

Overall Dimensions: 4-1/2” L X 5-1/2” H X 7/8” W

OPERA TING INSTRUCTIONS

1. Thread the nozzle or the needed extension onto the tip of the
Air Blow Gun.

2. Attach the Air Blow Gun to the air source hose. Set the air
compressor to 30 - 100 working PSI. Do NOT exceed 110 PSI.

3. Squeeze Air Blow Gun trigger to begin the flow of air.

4. Release Air Blow Gun trigger to stop the flow of air.

5. When finished, turn off the air compressor and then
disconnect Air Blow Gun from the air source hose

6. Only use c lean and dry compressed air. Never use o xygen,
carbon dioxide, combustible gases or any other bottled gas
as a power source.

09/06 Made in China.

For technical questions and replacement parts, please call Harbor

Freight T ools at 1-800-444-3353

1. Always wear ANSI-approved safety goggles when working
with tools and equipment.

2. Keep out of the reach of children.

3. Store Air Blow Gun Set in a dry and secure location.

4. Do not exceed the maximum air pressure of 110 PSI.

5. Do not modify any part of the Air Blow Gun Set to perform
any task for which they were not designed.

6. Never point the Air Blow Gun at peoples or animals.

7. Save these warnings.

SPECIFICATIONS

ITEM

95159