Center EHE0200361 RF User Manual

1

User Guide

EHE0200361 RF Programmable
Room Thermostat

The EHE0200361 RF programmable room thermostat is designed to control your heating
system efficiently, providing comfortable temperatures when you are at home and energy
savings when you are away. The following instructions explain how to program and use
the thermostat to provide the most home comfort at the least cost.

Description

OFFMANAUTO

Mon Tue We d Thu Fri Sat Sun

•

Ergonomic user interface featuring an ‘OK-button’.

• Large LCD (Liquid Crystal Display) Screen.

• 7-day heating program to match your lifestyle,
whilst maximising energy savings.

• 4 independent temperature levels per day (from
5°C to 35°C).

•

Built-in Memory holds the user program indefinitely.

Features of the EHE0200361

50039991-011 A

2 3

COPY

DAY

DAY

1.. 4

Mon Tue Wed Thu Fri Sat Sun

AUTO

MAN

OFF

PROGRAM

AUTO

LCD Screen

Battery Low Indicator

Time Display

Burner On Indicator

Day Indicator

Temperature Display

Temperature Change Buttons

Temperature Enquiry Button

1

2

3

9

10

11

4

5

Operating Mode Buttons

OK Button

Battery Compartment

Battery Cover

Program Buttons

Copy Day Button

Set Day Button

Time Change Buttons

12

13

14

15

Controls Layout

6

7

1 2 43 5

8

9

10

7

12

13

11

15

6

14

16

168

This section shows you how to setup and run the thermostat in 3 simple steps:

STEP 1: Installing the Batteries

Note: Please follow the instructions in this section only if the thermostat screen is
blank (no symbols or digits are displayed). If the room temperature is already displayed
move on to Step 2: Setting the Date and Time.

To install the Batteries:

a. Lift up the front cover of the thermostat to reveal the battery cover and product

controls.

b. Remove the battery cover by pressing down and sliding out.

c. Insert the 2 x AA LR6 Alkaline Batteries supplied with the thermostat, ensuring the

correct orientation (see ‘Controls Layout’ on page 2).

d. After a short pause the thermostat will display information on the screen and is now

ready for use.

e. Replace the battery cover by sliding it firmly back into the front of the thermostat.

STEP 2: Setting the Time

To set the Date and Time:

a. Press the DAY button once and the ‘day indicator’ will begin to flash.

b. Press the D AY button until the correct day is reached (Day 1 = Monday). Press the

button to confirm.

d. Press either of the or buttons once to enter time setting mode. The LCD

screen flashes the time digits (when the unit is powered for the first time the display
shows 12:00).

e. Use the or buttons to set the correct time then press the button to

confirm. Each press of the buttons will change the time by one minute and holding
them down will change the time slowly at first and get progressively quicker.

Note: If this mode is entered accidentally then press the AUTO, MAN or OFF

buttons to exit.

STEP 3: Running the Built-in Heating Program

The thermostat is now ready for operation. Press the AUTO button and the built-in
heating program will start running.

Note: The built-in heating program has been designed to provide normal comfort
requirements, but if you want to customise the settings please see the next section
‘Programming the EHE0200154’.

Setting-up the EHE0200361