C.E. Niehoff & Co. C527 Installation

C527 Alternator
Retrot/Upgrade Installation Instructions
Install alternator as shown in Figure 1:
1. Units are shipped with shaft collar, disc spring washer and nut. Remove and discard shaft collar. Install pulley and furnished disc spring washer. Torque nut to 135 Nm/ 100 lb. ft.
3. All cabling, wiring or conduit must be supported within 305 mm/12 in. of termination on alternator.
4. Choose wire gauge for B+ and B– cables capable of handling maximum alternator output with mini­mum voltage drop.
5. Install regulator as follows:
A2-334—install regulator on alternator and torque
mounting screws to 8.5 Nm/75 lb. in. Plug alterna­tor-to-regulator harness securely into regulator.
A2-335—install regulator in remote location as
specified by customer. Plug alternator-to-regulator harness securely into regulator.
A2-348—install regulator on alternator and torque
mounting screws to 8.5 Nm/75 lb. in. – Plug alternator-to-regulator harness securely into 5-socket receptacle on regulator. – Plug temperature sensing/voltage sensing harness from vehicle into 5-pin receptacle on regulator.
A2-350—install regulator in remote location as
specified by customer. – Plug alternator-to-regulator harness securely into 5-socket receptacle on regulator. – Plug temperature sensing/voltage sensing harness from vehicle into 5-pin receptacle on regulator.
6. Make electrical connections to regulator as required, using proper ring terminals (follow vehicle manufacturer’s diagram packed with extended wir­ing harness when used):
a. Make sure alternator-to-regulator harness
is plugged securely in regulator receptacle. b. Torque terminal nuts with disc spring washers to 4.5 Nm/40 lb. in.
• P terminal taps AC voltage, typically half the charge voltage.
• IGN terminal provides external energize on A2-334 and A2-335 regulators only.
Regulator P terminal; torque to 4.5 Nm/40 lb. in.
B+ terminal M10x1.5 Bolt – torque to 15 Nm/11 lb. ft.
M20x1.5 Nut
torque to 135 Nm/100 lb. ft.
Disc spring washer
Alternate mounting locations for A2-348 or A2-334 (3 different locations on circumference of shell)
B– terminal
M8x1.25 Bolt –
torque to 10.8 Nm/8 lb. ft.
Figure 1—C527 Alternator w/A2-348 Regulator (shown) Installation Details
C. E. Niehoff & Co. • 2021 Lee Street • Evanston, IL 60202 Tech Services Hotline 800-643-4633
Page 1 of 1
II178A
Loading...