Cellphone Mate SureCall M2M User Manual
Upli nk Fre q. Ra nge (MHz) 1850-1910 824-849
Down l i nk Freq. Ra n ge
1930-1990 869-894
Supp orted s ta ndards
Inp ut/Outpu t i mpe da nce
Max ga in
Nois e figure
VSWR
AC powe r tra nsforme r
Max ou tput po wer
Cab l e
RF con nectors
Power cons ump on
Di mens i o ns
We i ght
FCC ID (USA)
0.57 lb (260g)
RSNM2M
110VAC,60Hz I N / 5-12V D C OUT
1W EIRP
RG58
SMA Fema l e (both e n ds )
4.72”x2.72”x0.98” (120mm x 69mm x 25mm)
M2M Signal Booster Specifications
CDMA, GSM, EDVO,EDGE, HSPA,LTE
50Ω
15dB
5dB
≤2.0
4. Products sold by Cellphone-Mate, Inc. shall not be considered defective or non-conforming to the
Buyers’ order if they satisfactorily fulfill the performance requirements that were published in the
product specification literature, or in accordance with samples provided by Cellphone-Mate, Inc. This
warranty shall not apply to any products or parts thereof which have been subject to accident,
negligence, alteration, abuse, or misuse. Cellphone-Mate, Inc. makes no warranty whatsoever in
respect to accessories or parts not supplied by it.
SureCall M2M Signal Booster
* Not intended for Mobile Applications *
®
5. EXCEPT AS EXPRESSLY SET FORTH HEREIN, THERE ARE NO WARRANTIES, CONDITION
GUARANTEES OR REPRESENTATIONS AS TO MERCHANTABILITY, FITNESS FOR A PARTICULAR
PURPOSE OR OTHER WARRANTIES, CONDITIONS, GUARANTEES OR REPRESENTATIONS, WHETHER
EXPRESSED OR IMPLIED, IN LAW OR IN FACT, ORAL OR IN WRITING. CELLPHONE-MATE, INC.’S
AGGREGATE LIABILITY IN DAMAGES OR OTHERWISE SHALL NOT EXCEED THE PAYMENT, IF ANY,
RECEIVED BY CELLPHONE-MATE, INC. FOR THE UNIT OF PRODUCT OR SERVICE FURNISHED OR TO BE
FURNISHED, AS THE CASE MAY BE, WHICH IS THE SUBJECT OF CLAIM OR DISPUTE. IN NO EVENT
SHALL CELLPHONE-MATE, INC. BE LIABLE FOR INCIDENTAL, CONSEQUENTIAL, OR SPECIAL DAMAGES,
HOWSOEVER CAUSED.
6. All matters regarding this warranty shall be interpreted in accordance with the laws of the State of
California and any controversy that cannot be settled directly shall be settled by arbitration in
California in accordance with the rules then prevailing of the American Arbitration Association, and
judgment upon the award rendered may be entered in any court having jurisdiction thereof.
7. If one or more provisions provided herein are held to be invalid or unenforceable under applicable
law, then such provision shall be ineffective and excluded to the extent of such invalidity
or unenforceability without affecting in any way the remaining provisions hereof.
<10W
User Manual
Package Contents:
▪ M2M signal booster
▪ Magnetic mount antenna
▪ RG58 extension cable
▪ AC power supply
▪ Velcro and screw mounting kit
▪ User manual(this document)
FCC Information
This is a CONSUMER device.
BEFORE USE, you MUST REGISTER THIS DEVICE with your wireless provider and have
your provider’s consent. Most wireless providers consent to the use of signal boosters.
Some providers may not consent to the use of this device on their network. If you are
unsure, contact your provider.
You MUST operate this device with approved antennas and cables as specified by the
manufacturer. Antennas MUST be installed at least 20 cm (8 Inches) from any person.
You MUST cease operang this device immediately if requested by the FCC or a
licensed wireless service provider.
WARNING. E911 locaon informaon may not be provided or may be inaccurate for
calls served by using this device.
CM-M2M 201401 v1.1
888.365.MATE (6283) phone - (510)996-7250 fax
www.surecall.com | Fremont, CA 94538 (USA)
The CM-M2M Booster by Cellphone-Mate, Inc. provides significantly increased cellular signal strength
-
3dBi
-
and quality. You will see the difference in the number of bars on your display and hear the difference
during your conversations.
Mounting & Connecting the Booster
Connecting the Booster: The signal is received by the antenna from the cell tower, then AMPLIFIED and
transmitted directly to your wireless modem (in the ATM, lotto machine or other machine-to-machine
application) through the cable to the booster. When the modem transmits, the signal is received by the
booster, then AMPLIFIED and transmitted to the cell tower through the outside antenna.
Connect the Antenna: Attach the magnetic mount antenna to any metallic surface. The best location will
be clear of obstacles. Make sure the area under the magnet is clean. Connect the magnetic antenna
cable to the “OUTSIDE” connector of the booster and tighten it.
WARNING: The antenna must not be co-located or operating in conjunction with any other antenna or
booster.
Connect the Modem (inside ATM, lotto machine or other modem applications): Connect one end of the
RG58 extension cable to the booster marked “INSIDE”and the other end to the modem and tighten both
connections.
Connect the Power Cord: To prevent damage to the booster, before plugging in the booster to an AC
power outlet, make sure the booster’s power switch is in the OFF position. Then connect the AC power
cord to the booster. Then connect the free plug to the outlet. Make sure that all of the connections to
the booster are tight and secure, then turn on the booster’s power switch. The LED light will glow
indicating that the booster is ready to use.
(Optional) Mounting the Booster with Velcro: You can leave the booster on top of a flat surface or use
the enclosed Velcro straps to mount it. There are two 6cm x 2.5cm Velcro strips (hook-and-loop pairs)
in the box for mounting the booster.
Using the Booster
The booster is ready for use as soon as all connections are made and the unit powers up without the
red light coming on. You may now place and receive cellular phone calls with powerful signal
amplification.
Note: The booster case may become warm during operation. This is normal. Press any key on your cell
phone to refresh communication with the base station.
Troubleshooting
If the booster interferes with your radio or other electronic receivers, move the booster further away
from those devices. For a list of Frequently Asked Questions and a complete, up-to-date
Troubleshooting Guide, please visit our website at: www.surecall.com. You may also consult a
Cellphone-Mate technical specialist directly by emailing us at support@Cellphone-Mate.com.
Antenna Kitting Information
Component Pr o d N o . Descritpion
Option #1 CM200-S-S
CM174
Option #2 CM288W
10Feet
CM240-40FN 40Feet
Antenna
Warranty
1. Cellphone-Mate, Inc. warrants to the buyer that each of its products, when shipped will be free from
defects in material and workmanship and will perform in full accordance with applicable
specifications. The limit of liability under this warranty is, at Cellphone-Mate, Inc.’s option, to repair or
replace any product or part thereof which shall within TWO YEARS of purchaseas determined by
examination by Cellphone-Mate, Inc., prove defective in material and/ or workmanship. Warranty
returns must first be authorized in writing by Cellphone-Mate, Inc. Disassembly of any Cellphone-Mate,
Inc. product by anyone other than an authorized representative of Cellphone-Mate, Inc. voids this
warranty in its entirety. Cellphone-Mate, Inc. reserves the right to make changes in any of its products
without incurring any obligation to make the same changes on previously delivered products.
2. As a condition to the warranties provided for herein, the Buyer will prepay the shipping charges for
all products returned to Cellphone-Mate, Inc. for repair, and Cellphone-Mate, Inc. will pay the return
shipping with the exception of product returned from outside the United States in which case the
Buyer will pay the shipping charges.
3. The Buyer will pay the cost of inspecting and testing any goods returned under the warranty or
otherwise which are found to meet the applicable specifications or which are not defective or not
covered by this warranty.
Loading...