Celestron 21041 User Manual

Use the three tightening screws located at the
bottom of each leg to secure the extended legs
in place.

To set up the tripod, spread the legs outward
until they are fully extended and push down
center locking brace. Extend the center portion
of each of the three tripod legs down 6-8".

Item #31132

Quick Set-up Guide

1

2

3

All three legs should be the same length to
provide a level platform for the telescope.

4

7

Locate the optical tube and line up the tube
with the holes on the mount.

5

Properly assembled, the accessory tray should
appear as pictured above.

6

Secure the tube to the mount using the two
threaded mounting bolts. Tighten to secure in
place.

8

Insert the slow motion control rod into the hole
on the mount.

9

PowerSeeker 60AZ

Your PowerSeeker 60AZ includes: optical tube with
two threaded mounting bolts; tripod with center
support bracket & yolk mount attached; two
eyepieces; a 3x barlow lens, finderscope; star
diagonal; slow motion control rod; eyepiece
accessory tray; The Sky™ CD software; owner’s
manual.

Item# 21041

Place the accessory tray on top of tripod's
center leg brace. Thread the tray into the
threaded hole in the center of the leg brace.

Questions or Problems with Set-up?

CONTACT:

Celestron Technical Support: 310.803.5955

Quick Set-up Guide [cont]

Secure slow motion control rod to telescope
tube by attaching the included bolt and
tightening.

11

Locate the finderscope. Remove the knurled
nuts on the threaded posts at the focuser end
of the telescope tube.

12

13

Loosen the set screw on the focuser so that it
does not obstruct the inner diameter of the
focuser. Remove the plastic cap covering the
end of the focuser.

14

Locate the diagonal and remove the plastic
covers. Insert the chrome barrel of the
diagonal into the focuser and secure in place
by tightening the set screw.

15

Insert the chrome barrel of the 20mm eyepiece
into the diagonal and tighten the set screw.

16

Remove the lens cap from the front of the
telescope. To observe, look through the
eyepiece as shown above.

17

18

Insert the chrome barrel of the 20mm eyepiece
into the barlow and tighten the set screw to
secure in place.

10

For additional magnification, you can use the
included 3x barlow. Place the barlow in the
diagonal in place of the eyepiece and tighten
set screw -- remove the cap from the barlow.

Orient the finderscope so that the lens window
is facing towards the front of the tube. Place
finderscope over the posts on the tube and
replace knurled nuts.

For detailed usage information please consult your

owner’s manual.