PANINI / SANDWICH GRILL
Single, Single Plus & Double Models
SG-1SG
SG-1LG
SG-1LF
SG-2LG
OPERATION MANUAL
SG-1SG Shown
CECILWARE CORPORATION
43-05 20th AVENUE, LONG ISLAND CITY, NEW YORK 11105-1295 ■
718-932-1414 FAX 718-932-7860 www.cecilware.com
NN55A 5/05
TABLE OF CONTENTS
Introduction .............................................................. page 2
Packaging ................................................................. page 2
Installation.................................................................. page 2
Operation .................................................................. page 3
Cleaning, Care and Maintenance ............................ page 3
Safety ........................................................................ page 3
Trouble Shooting ..................................................... page 4
Compliance ............................................................... page 5
Electrical Diagram .................................................... page 5
Explosion View ......................................................... page 6-9
Specifications............................................................. page 9
Spare Part List .......................................................... page 10
1
Introduction
Congratulations on the purchase of your Cecilware Panini Sandwich Grill. Please take a few moments
to carefully read through this manual to ensure that the machine is operated and maintained properly.
This will enable the best possible performance from this product for many years.
Cecilware will not accept liability for the following if:
* The instructions in this manual have not been followed correctly.
* Non-authorized personnel have tampered with the m achine.
* Non-original spare parts are used.
* The machine has not been handled and cleaned correctly.
Packaging
Cecilware prides itself on quality and service, ensuring that at the time of packing, all products are
supplied fully functioning and free of damage.
Provided in this package are the following:
* Contact Grill
* Drip Tray
* Manual
Should you find any damage as a result of freight, please contact your Cecilware dealer immediately.
Installation
Remove the Cecilware Panini Sandwich Grill from the packaging. Be certain all protective plastics and
residues are thoroughly cleaned from its surface.
Place the Panini Sandwich Grill on a firm level surface.
Local standards and regulations should be consulted in order to abide by standards set in relation to
positioning, spacing and ventilation. Cecilware recommends that you allow no less than 4” ventilated
gap around the perimeter of this unit. Common sense and initiative should be used when choosing the
position and operation of this product.
Caution:
Do not position or operate near combustible materials or flammable objects.
Once your Panini Grill has been placed into position, be sure that the stainless steel waste tray is
correctly positioned.
Supply the appropriate power and connect to source; your Panini Sandwich Grill is now ready to turn
on and operate. (For power supply, please see technical specification sheet, page 9)
Preparing the cooking surface:
Be sure the cooking surface is clean; then simply turn the unit on and apply a generous amount of oil to
the plates. Using the thermostat, set the grill to 230º F; once the grill has reached the desired
temperature, switch off and wipe the plates clean of excess oil.
Caution: The grill and oil will be HOT!!!
2
Operation
Your Panini Sandwich Grill should be turned on prior to usage to allow the cooking surface to warm up;
5 minutes is sufficient for preheating.
To get efficient use out of this unit while in intermittent use, it is recommended that the grill plates
remain closed and that the thermostat is turned down, when not cooking. This will assist in reducing
power consumption and also allow for quicker heat response when needed.
Cecilware recommends that the cooking surface be lightly greased before each use.
A temperature setting of between 390º F and 430º F will be sufficient for general cooking. This may
vary for particular food types, individual needs, or experience.
Simply place the food product on the bottom grilling surface, lower t he top plate down, and co ok to your
needs.
Cleaning, Care and Maintenance
Switch the power off and disconnect from the power source.
*The Panini Sandwich Grill should be cleaned regularly throughout use, and thoroughly
cleaned after each meal preparation. Regular cleaning will result in easier cleaning. Correct
preparation of the cooking surface when first used, will assist in keeping the plates clean.
*For best results, clean the plate while still warm using warm soapy water. A nylon cleaning cloth can
be used, but it is recommended that scrapers such as steel wool etc., be avoided, as they will damage
the plates. Do not use cold water on warm plates; a bucking effect may occur.
*When scrubbing the plates, do not clean too thoroughly. If you do, you may have to prepare the
cooking surface again before use.
*Remove drip tray from unit and discard waste. Clean in hot soapy water.
*The remainder of the griddle can be cleaned with a damp cloth using hot, soapy water.
*Warm soapy water is recommend ed for cleaning; strong cle aning agents may damage stainless steel.
Safety
A Cecilware Recommended Qualified Service Technician should carry out repairs if necessary. Do not
remove any components or service panels on this product.
*During operation, the Panini Sandwich Grill reaches high temperatures on the cooking surface, which
in turn heats the stainles s steel surfaces. To eliminate accidents, use the black handles when in contact
with the grill.
*Switch off power to and disconnect from the power supply when cleaning.
*Allow the Contact Grill to cool down after use before dismantling for cleaning; the unit will still be too
hot to handle immediately after use.
*This unit has been equipped with a thermal cut-off safety device to avoid over heating.
*Do not immerse unit in water or use hose to clean.
*If the power cord is damaged, it must be replaced by a Cecilware Recommended Qualified Service
Technician in order to avoid a hazard.
3
Trouble Shooting
If your Cecilware Panini Sandwich Grill does not operate, please check the following before placing a
service call.
Contact Grill SG-1SG, SG-1LG, SG-1LF, SG-2LG
Problem Cause Remedy
1. Mains power supply. 1. Check mains power supply.
The unit is not working
and the indicator light is
not on.
The unit is heating but
the indicator light is not
on.
Indicator light is on but
the unit is not heating.
2. Power switch has not
been turned on.
3. Fuse in the plug has
blown.
2. Check the unit is correctly plugged in and
turned on.
3. Replace the fuse in the plug with correctly
rated fuse.
4. On/off switch is faulty 4. Call service agent or qualified technician.
5. Plug and lead are
damaged.
5. Call service agent or qualified technician.
6. Internal wiring fault. 6. Call service agent or qualified technician.
7. Thermal cut-out has
activated.
1. The indicator bulb has
blown.
7. This is a safety device that has
disconnected the power: call a service
agent or qualified technician.
1. Replace the indicator light: call a service
agent or qualified technician.
1. Faulty element(s). 1. Call service agent or qualified technician.
2. Ensure that the thermostat is set correctly,
2. Operation of thermostat.
also ensure the dial is not spinning on the
thermostat and giving the wrong reading.
3. Faulty thermostat. 3. Call service agent or qualified technician.
1. Carbon build up.
Slow heat up of the
cooking surfaces.
2. Thermostat setting.
3. Faulty element(s). 3. Call service agent or qualified technician.
Please ensure:
* Correct power supply.
* The machine is plugged in correctly and power is switched on.
* The thermostat is in the correct position.
Note: All Cecilware products are tested prior to packing.
4
1. Ensure that the plates are kept clean and
free of carbon build up.
2. Ensure that the thermostat is set correctly,
also ensure the dial is not spinning on the
thermostat and giving the wrong reading.
Compliance
Cecilware products have undergone strict product testing in order to comply with regulatory standards
and specifications set by international, independent, and federal authorities.
As testimony to such compliance, Cecilware products carry the following marks/symbols:
Electrical Diagram
Model: SG-1SG, 1LG, 1LF
120/240V
hi-limit
SG-2LG
hi-limit 1
on/off
switch 1
thermostat 1
on/off
switch
thermostat
pilot light 1
top element 1
240V
pilot light
top element
bottom element
hi-limit 2
on/off
switch 2
thermostat 2
pilot light 2
top element 2
bottom element 1
bottom element 2
The above circuit diagram has been provided to assist qualified technicians. A Recommended
Qualified Service Technician should carry out repairs if needed. Do not remove any components or
service panels on this product.
5
Explosion View
SG- 1SG
23
27
26
25
24
1
5
10
6
11
3
4
2
7
8
9
13
12
14
15
16
22
21
20
17
19
18
6
SG – 1LF
25
24
27
26
1
2
3
4
5
6
7
8
9
10
23
11
12
14
22
21
20
19
13
15
16
17
18
7
SG – 1LG
25
24
27
26
1
2
3
4
5
6
7
8
9
10
23
11
12
14
22
21
20
19
13
15
16
17
18
8
SG – 2LG
24
25
27
26
1
2
3
4
5
6
7
8
9
Specifications
Cecilware
Model
SG-1SG
Voltage
50/60HZ
23
120V
22
21
20
Power Dimensions (inches)
(watts)
1800
19
W×D×H
11 3/8”×15 3/8”×9 1/8”
18
10
11
12
13
15
14
16
17
Grill Type
Top Bottom
Grooved Grooved
SG-1LG Grooved Grooved
SG-1LF
SG-2LG
240V
50/60 HZ
240V
50/60 HZ
2400
3200
16 1/8”×17 1/2”×9 1/4”
18 3/4”×15”×9 1/8”
Flat Flat
Grooved Grooved
9
Spare Parts List
No. Description
SG-1SG SG-1LG/SG-1LF
QTY
Part
NO.
QTY Part NO. QTY
SG-2LG
Part NO.
1 TOP COVER (LID) 1
NA
1 NA 2 NA
2 MAIN HANDLE (LARGE) 1 08068 1 08062 2 08080
3 ELEMENT FIXING PLATE (UPPER) 1 NA 1 NA 2 NA
REAR SPRING COVER (SHEET
4
METAL)
1 NA 1 NA 2 NA
5 HEATING ELEMENT (UPPER) 1 08069 1 08063 2 08081
6 CAST PLATE (UPPER) 1 NA 1 NA 2 NA
7 CAST PLATE (LOWER) 1 NA 1 NA 1 NA
8 HINGE 1 08070 1 08064 2 08082
9 PLATE CONNECTING SPRING 1 08074 1 08074 2 08074
10 HEATING ELEMENT (LOWER) 1 08071 1 08065 2 08083
11 INSULATI0N CLAMP (LOWER) 1 NA 1 NA 1 NA
12 HI LIMIT 1 08079 1 08079 2 08079
13 MAIN BODY (BODY WRAP) 1 NA 1 NA 1 NA
14 CORD AND PLUG 1 08055 1 08047 1 08047
15 CERAMIC TUBE (INSULATOR) 3 08077 3 08077 5 08077
INSULATION （LOWER）
16
1 NA 1 NA 1 NA
17 BASE PLATE (LOWER) 1 NA 1 NA 1 NA
18 FEET 4 08075 4 08075 4 08075
19 THERMOSTAT 1 08078 1 08078 2 08078
20 THERMOSTAT DIAL 1 08041 1 08041 2 08041
21 PILOT LIGHT 1 08032 1 08067 2 08067
22 ON/OFF SWITCH 1 08073 1 08054 2 08054
23 DRIP TRAY (GREASE TROUGH) 1 08072 1 08066 1 08084
24 ELEMENT FIXING PLATE (LOWER) 1 NA 1 NA 2 NA
25 SMALL HANDLE (FRONT) 1 08076 1 08076 2 08076
26 INSULATION CLAMP (UPPER) 1 NA 1 NA 2 NA
INSULATION （UPPER）
27
1 NA 1 NA 2 NA
*NA = not available except by special order.
10
CECILWARE CORPORATION
43-05 20
th
AVENUE, LONG ISLAND CITY, NEW YORK 11105-1295 ■
718-932-1414 FAX 718-932-7860 www.cecilware.com
11
Loading...