Cecilware CME10E-N Installation Manual

"A"

ME10E-N

CAUTION

HOT SURFACES

TEMPERATURE CONTROL

VENT OPENING
POWER

SUPPLY BOX

POWER ON
LIGHT

HEATER ON
LIGHT

POWER
SWITCH

TEMPERATURE
CONTROL

4.0

OVERFLOW

THERMOMETER

14.0 4.0

SIDE ACCESS DOOR
(SLIDES UP)

WATER INLET

16.03.4

NOTE:

1. FIELD WIRING MUST BE SUITABLE FOR 75 DEGREES CELSIUS.

2. USE COPPER WIRE ONLY FOR POWER SUPPLY CONNECTION.

3. 120 VOLT UNITS SUPPLIED WITH A GROUNDED 120V-15A LINE CORD AND PLUG.

AUTOMATIC

HOT WATER BOILER

WARRANTY

Every Cecilware product has been carefully inspected before shipment. The finest materials and the highest
standards of workmanship have been built in to the equipment.
Within 1 year of purchase, should any Cecilware product show defect in factory workmanship or material,
we agree to repair at our option or replace without cost to user, such parts which prove upon factory
inspection to have been so defective. All equipment must be shipped transportation charges prepaid for
acceptance. This warranty covers replacement parts only; labor charges are covered for 90 days after
installation.

This warranty does not apply under the following conditions:

• neglect or abuse of equipment

• excessive lime condition

• improper installation

• any outside modification to equipment

Every Cecilware urn body is covered for three years. This warranty covers the stainless steel body and
stainless steel liners only.
Portable equipment such as Electric Fryers, Food Warmers, Electric Stoves, Dispensers, Plug-In Urns, Coffee
Brewers and Warmers must be returned to the factory or brought to an authorized service station for repair.

UNPACKING INSTRUCTIONS:

Carefully unpack the water boiler and inspect immediately for shipping damages. Your automatic water

boiler was shipped in a carton designed to give maximum protection in normal handling. It was thoroughly
inspected before leaving the factory and the carrier accepted and signed for it. File any claims for shipping
damage or irregularities directly with the carrier.

ASSEMBLY:

The four legs, faucet, vent cap drain, and hose nut are packed separately with the water boiler. Install legs

by tilting the water boiler on its side and screwing the legs in the leg supports until hand tight. Carefully
right the unit and install it in its permanent location, being sure to leave at least 6” on the right side of the
water boiler for access to the controls. Level the unit by adjusting the bottom pad of the legs. Place the vent
cap in to the recess in the top of the unit. Mount the faucet assembly on to the shank.

INSTALLATION INSTRUCTIONS FOR WATER BOILERS

Water boilers are shipped with the thermostats in the OFF position. Do not turn the thermostat on before
filling the water boiler with water.

NOTE: When positioning the unit, leave a minimum of 6” clearance on the right side of the water boiler for
ease of service.