Cecilware AG-120B Service Manual

AG120
AG 120B

CONTENTS

• GAS DATA

• GENERAL SPECIFICATIONS

• UNPACKING AND INSPECTION

• INSTALLATION

• OPERATION

• MAINTENANCE

• ADJUSTMENTS

• PARTS LIST

HEAVY DUTY

COMMERCIAL

HOT PLATE

STANDARD FEATURES

1.18 gauge aluminized steel unibody construction.

2.18 gauge stainless steel front panel.

3. Durable cast iron burners.

4. Cast iron top grate.

5. Non-corrosive aluminum drip pan.

6. Supplied with adjustable N.S.F. listed legs.

7. Design A.G.A. certified and N.S.F. listed.

8. M.E.A. listed

FOR YOUR SAFETY

DO NOT STORE OR USE GASOLINE OR OTHER FLAMMABLE VAPORS AND LIQUIDS IN

THE VICINITY OF THIS OR ANY OTHER APPLIANCE.

THIS INSTALLATION MUST CONFORM WITH THE NATIONAL FUEL GAS CODE

ANSI Z223.1 (Latest Edition).

WARNING: IMPROPER INSTALLATION, ADJUSTMENT, ALTERATION OR MAINTENANCE

CAN RESULT IN PROPERTY DAMAGE, INJURY OR DEATH. READ THE INSTALLATION,

OPERATION AND MAINTENANCE INSTRUCTIONS THOROUGHLY BEFORE INSTALLING

OR SERVICING THIS EQUIPMENT.

CECILWARE CORPORATION

43-05 20th Avenue, Long Island City, N.Y. 11105 • 718-932-1414

N765A4/99

FOR YOUR SAFETY

DO NOT STORE OR USE GASOLINE OR OTHER FLAMMABLE VAPORS AND

Natural or Liquefied Propane Gas

LIQUIDS IN THE VICINITY OF THIS OR ANY OTHER APPLIANCE.

SAFETY PRECAUTIONS

FOR YOUR SAFETY, THE FOLLOWING SAFETY PRECAUTIONS SHOULD BE FOLLOWED

AND ENFORCED.

Instructions must be posted in a prominent location and all safety precautions taken in the event the user smells

gas. Obtain this information from your local gas supplier.

1. IF YOU SMELL GAS:

A. OPEN WINDOWS C. EXTINGUISH ANY OPEN FLAMES
B. DON'T TOUCH ELECTRICAL SWITCHES D. IMMEDIATELY CALL YOUR GAS SUPPLIER

2. LIGHTING — Follow the instructions on page 3 and on label attached to right side of unit.

3. Do not place combustibles or non-combustible materials in the vicinity of the hot plate as this could cause fires or
obstruct air to the main burners.

4. This installation must conform with local codes, or in the absence of local codes, with the National Fuel Gas Code,
ANSI Z223.1 latest edition.

5. Provide adequate air supply and ventilation.

6. Provide adequate clearance for air openings into the combustion chamber.

7. Provide clearances for servicing and proper operation. Minimum clearance from combustible construction, 6" from
side and 6" from back.

8. Hot plate must be disconnected from gas supply during any pressure testing of pipelines in excess of 1/2 psig, and
isolated by turning off manual gas shut-off valve during any testing equal to or less than 1/2 psig.

9. Retain this manual for future reference.

General Data Gas Data

Model No. Dim. A. Dim. B.

AG-120 11 3/8 4 1/4 55 10,000 7,000

AG-120B 16 7/8 9 3/4 65 10,000 7,000

Shipping Wt.

(Lbs.)

Front

Burner

BTU/HR

Rear

Burner

BTU/HR