CDVI PROMI E Wiring Diagram And Instruction Manual

5/2004 G0301FR0226V01 Edition 0

A. Features

Input voltage 12v AC/DC

12-digit keypad
EPROM memory storage
100 Pin codes, 3 to 8-digit Pin code
1 relay output N/O and N/C contact 3A/125V~
3 to 8-digit master code
Audible and visual signal indication
1 request-to-exit input

WIRING DIAGRAM AMD INSTRUCTIONS

PROMI E

100 Pin codes

I. PRESENTATION

This device comes with a varistor.
The varistor must be connected to the strike terminal
(electromagnet…) operated by the device.
If this product works with many strikes, each of them
should have a varistor.
The varistor controls the overload produced by the strike
coil – emf.

If you are using a « Shear Loc

k

» electromagnetic lock, it is recommended to

use a separate power supply than the one connected to the PROMI/ECO !

2

B. Factory default values

Key-in keypad time: 10 seconds.
Door release time: 1 second
Programming time: 2 minutes

5-digit Pin code and master code: 12345

C. Audible signals

1 short beep Press a digit keypad
1 long beep Data validated in programming or access granted
2 short beeps Entry or exit from programming
4 short beeps Data computing error

D. Visual signals

LED colour

Normal operating

programming

Flashing orange Stand-by Data computing error

Orange Programming menu

Green Access granted User number empty

Red User number busy

E. Consumption

In stand-by: 4 mA In use: 15 mA max

II. PROGRAMMING

A. Time outputs

Enter the master code twice (for the first use the master code default value is 12345). The orange LED
lights and two beeps sound to confirm entry into programming mode.

Press ¿0 then enter the ‘key in’ time in seconds: 10 for 10 seconds up to 99 for 99 seconds. The LED lights
off during 1 second and a beep will sound to confirm that the time has been accepted.

Press ¿1, then enter the door release time in seconds: 01 for 1 second up to 99 for 99 seconds. Enter 00 for
a latched output. The LED lights off for 1 second and a beep will sound to confirm that the time has been
accepted.

Press # to exit from programming mode. 2 beeps confirm that unit is back to re ading mode.
4 beeps indicate a data computing error.

B. Code length

Enter the master code twice (for the first use the master code default value is 12345). The orange LED and
two beeps sound to confirm entry in the programming mode.

Press ¿2 to program the code length then enter 3, 4, 5, 6, 7 or 8 The LED lights off for 1 second and a beep
sound to confirm that the new code length has been accepted.

IMPORTANT:

When the code length has been modified, the Master code should be reprogrammed, in

the new code format, also while in programming.