CDVI KCIENSBP, KCIEN Installation Manual
All the specications on this document (photos, drawing, features and dimensions) could be changed without prior notice.
INSTALLATION MANUAL
Heavy Duty Stainless Steel
Illuminated Keypads
KCIENSBP
KCIEN
Range: DIGICODE® (Stand-Alone Keypad)
c d vi . co m
c d vi g ro u p. c o m
Installation Manual
Stand-Alone Keypads
Installation Manual
Stand-Alone Keypads
c d vi . co m
c d vi g ro u p . co m
1 2
• Input voltage:
12V to 24V AC or 12V to 48V DC
• Illuminated keys
• Heavy duty stainless steel, vandal, dust &
weather resistant (IP 64 DM)
• EEPROM memory storage
• 100 user codes (PIN) (4 to 6 digits)
• 2 form C outputs 6A @ 250V~
• 1 programmable master code
• Buzzer audible signal
• 1 request-to-exit input
• Maximum Consumption:
When 2 relays activated with
permanent keypad illumination
12V DC: 90mA max - 24V DC: 50mA max
12V AC: 70mA max - 24V AC: 40mA max
Features: Default Values:
• Touch-activated illumination time: 10 secs
• Relay activation time: 1 second
• Code length: 5 digits
• Master code: 12345
• Programming mode time out: 120 seconds
• Sub-master code (00 to 59):
*
then #
• Sub-master code (60 to 99):
1
then 3
CONTENTS:
Varistor
Tool
Wall Plate
Screw
Wall
Plate
Jumper
Plastic
anchor
Wood
screw
3 x 40
mm
1 1 1 1 1 2 2
ST3
Tamper
Piezo
Black (ground)
Red
Pink (Request-to-exit)
Purple (Common)
Dark Green ( * Request-to-enter)
Green/White (N.C. Relay 2)
Blue/Red (Com. Relay 2)
Pink/Grey (N.O. Relay 2)
Orange (N.C. Relay 1)
Yellow (Com. Relay 1)
Brown (N.O. Relay 1)
Light Blue (* Request-to-enter)
Light Green ( User can change their own code)
White
Grey
Tamper
Input Voltage
12 to 24 Vac or 12 to 48 Vdc
Com.N.O.
Optional
Programmable timer
TH827-12V
* It will open the door at any time on request-to-enter using
the selected key (Dark Green: Any keypad key, Light Blue:
KCIEN button). Use the optional programmable timer to
control the request-to-enter time, see diagramm.
Reset to
factory default:
1. Turn OFF the power.
Put ST3 jumper as shown on diagram
2. Turn ON the power. Wait a few seconds, one beep
is emitted. Remove ST3 jumper.
3. The keypad is reset to factory default values and
all user codes are deleted.
c d vi . co m
c d vi g ro u p . co m
Installation Manual
Stand-Alone Keypads
Installation Manual
Stand-Alone Keypads
c d vi . co m
c d vi g ro u p . co m
3 4
To Purple
To Dark Green or
Light Blue
Loading...