CDA HVN93 Manual For Installation, Use And Maintenance
1
Customer Care Department • The Group Ltd. • Harby Road • Langar • Nottinghamshire • NG13 9HY
T : 01949 862 012 F : 01949 862 003 E : service@cda.eu W : www.cda.eu
HVN93 Induction Hob
Manual for Installation, Use and Maintenance
2 3
Important
The CDA Group Ltd cannot be held responsible for injuries or losses caused by incorrect use or installation of this product. Please
note that CDA reserve the right to invalidate the guarantee supplied with this product following incorrect installation or misuse
of the appliance or use in a commercial environment.
This appliance is not designed to be used by people (including children) with reduced physical, sensorial or mental capacity, or
who lack experience or knowledge about it, unless they have had supervision or instructions on how to use the appliance by
someone who is responsible for their safety.
Under no circumstances should any external covers be removed for servicing or maintenance except by suitably qualified
personnel.
Appliance information:
Please enter the details on the appliance rating plate below for reference, to assist CDA Customer Care in the event of a fault with
your appliance and to register your appliance for guarantee purposes.
Appliance Model
Serial Number
CE Declarations of Conformity
This appliance has been manufactured to the strictest standards and complies with all applicable legislation, including Electrical
safety (LVD) 2006/95/EC and Electromagnetic interference compatibility (EMC) 2004/108/EC. Parts intended to come into
contact with food conform to 89/109/EC.
IMPORTANT INFORMATION FOR CORRECT DISPOSAL OF THE PRODUCT IN ACCORDANCE WITH EC DIRECTIVE
2002/96/EC.
At the end of its working life, the product must be taken to a special local authority waste collection centre or to a dealer
providing appliance recycling services.
Disposing of a household appliance separately avoids possible negative consequences for the environment and health. It also
enables the constituent materials to be recovered, saving both energy and resources. As a reminder of the need to dispose of
household appliances separately, the product is marked with a crossed-out wheeled dustbin.
Please note:
• Induction hobs become hot and remain hot during and immediately after use. Do not touch the hob until it has been allowed
to cool.
• Keep children away from the appliance when in use.
• Never use the hob top for storage.
• Pan handles should never stand out beyond the edge of the worktop. This will ensure children cannot reach them.
• Do not lean over the hob when it is in use.
• Follow the cleaning instructions carefully.
• Ensure the base of the saucepan is clean and dry before placing it on the hob.
• Avoid hard shocks from cookware – the vitroceramic glass surface is highly resistant but not unbreakable.
• Do not place hot lids flat on the hob top. A “suction” effect could cause damage to the hob.
• Do not drag cookware across the hob top: in the long term, this could cause damage to the hob.
• Do not store cleaning or flammable products in the unit below the hob.
• Always use appropriate cookware.
• Do not cook unopened tins of food directly on the hob.
• Never put cooking foil or plastic materials on the ceramic surface when the hob is hot. These materials could melt
and cause damage to the hob.
• This hob (Class 3) has been designed for use only as a cooking appliance. Any other use should be considered
incorrect and therefore dangerous.
FOR THOSE WITH HEART PACEMAKERS OR ACTIVE IMPLANTS:
The function of this hob conforms to current electromagnetic interference standards and thus is in total compliance
with legal requirements (2004/108/CE directives).
To avoid interference between your hob and a pacemaker, your pacemaker must be designed and programmed in
compliance with the regulations that apply to it. As such, CDA guarantee only that our product is compliant.
With regard to the compliance of the pacemaker or any potential incompatibility, you should obtain information from
the manufacturer or your attending physician.
Important
• Do not use the hob if the glass surface is cracked or damaged to prevent the risk of electric shock. Disconnect it
from the power supply.
• Ensure that the power cable of a connected electrical appliance near the hob is not in contact with the
cooking zones.
Cooking on Induction
The principle of induction cooking is based on magnetic effect.
When you put your cookware on an induction zone and switch it on, the electronic boards in the hob produce induced
currents in the base of the cookware and instantly raise its temperature. This heat is then transferred to the food inside
the cookware.
The best cookware to use with induction cooking has thick flat bases, as the heat will be better distributed so cooking
more evenly.
Most cookware is compatible with induction cooking.
There are three ways to check the suitability of your cookware:
1. Using a magnet to see if the base of the pan is magnetic: if three magnet sticks, then the cookware is compatible.
2. Place the pan on one of the cooking zones and switch the zone on. If the display continues to show the selected
power level then the cookware is compatible. If the display shows , the cookware cannot be used on an
induction hob.
4 5
Using your Hob
Control panel:
1. Front left 2.3-3kW 200 mm
2. Centre left 1.4 kW 160 mm
3. Centre right 1.4 kW 160 mm
4. Front right 2.3-3kW 200 mm
5. Power key
6. Slider control
7. Booster key
8. Pause/restart key
9. Timer key/display
10. Zone key/displays
The table below offers guidance to each power level:
Power level Type of cooking
0 Switched off
1/2 For melting (butter/chocolate) or keeping food warm
2/3 Keeping food hot or to heat small quantities of liquid
3/4 Heat larger quantities of liquid (sauces etc.)
4/5 Slow boiling, e.g spaghetti, soups, stews, potatoes
6/7 Gentle frying
7/8 Browning meats, frying fish, omelettes
9 Fast frying steaks
Fig.1
1
2
4
3
5
Using your Hob
To switch the zone on
• To switch the power on, touch and hold for approximately two seconds. The hob will beep and all four zone displays will
show 0.
Please note: If a power level is not set within twenty seconds, the hob will switch off automatically.
To set the power level
• Touch the zone display for the required zone. The hob will beep and the zone display will show a .(dot) in the bottom
right corner.
• Then touch the slider control at the required point, or move up or down the slider until the zone display shows the required
power level from 1 (minimum) to 9 (maximum).
Please note: After zone selection, the zone will remain active for approximately ten seconds. If no key is touched during this
time, the zone will become inactive, and the hob will switch off automatically after a further ten seconds if no zones are in use.
To turn the power off
• To switch off a single zone, touch the zone display to make the slider active for the required zone, then set the slider to 0
for the zone no longer required. When all the zones are at 0, the hob will switch off automatically after approximately
twenty seconds.
• Alternatively, to switch off the hob immediately, touch and hold for approximately two seconds.
Booster
• The hob is equipped with a booster function on the front left and front right zones, allowing a higher power level than the
maximum for approximately five minutes. To turn on the booster function, touch the zone display for the required zone then
touch . P will show in the zone display whilst the booster is on. To cancel the booster at any time, touch the zone display to
activate the slider, then set the required power level.
Auto-heat
• Every zone is equipped with an auto-heat function, which reduces the warming up time for the zone. To turn on the auto-
heat function, touch the zone display for the required zone, then set the power level to 9 using the slider control.
• Touch the 9 position on the slider control again and the display will alternate between 9 and A.
• Then select the power level required. The display will alternate between the set power level and A for a preset period of
time, before reducing the power to the level required.
• If no final power level is set, the auto heat is switched off and the zone will remain on power level 9.
6 7 8
10
9
10
Loading...