CDA EXTRACTORS CIGE9 Installation And Maintenance Manual

Customer Care Department • The Group Ltd. • Harby Road • Langar • Nottinghamshire • NG13 9HY

T : 01949 862 012 F : 01949 862 003 E : [e-mail] W : www.cda.eu

CIGE9 Extractors

Manual for Installation, Use and Maintenance

Important

The CDA Group Ltd cannot be held responsible for injuries or losses caused by incorrect use or installation of this
product. Please note that CDA reserve the right to invalidate the guarantee supplied with this product following incorrect
installation or misuse of the appliance or use in a commercial environment.

This appliance is not designed to be used by people (including children) with reduced physical, sensorial or mental
capacity, or who lack experience or knowledge about it, unless they have had supervision or instructions on how to use
the appliance by someone who is responsible for their safety.

Under no circumstances should any external covers be removed for servicing or maintenance except by suitably qualified
personnel.

Appliance information:

Please enter the details on the appliance rating plate below for reference, to assist CDA Customer Care in the event of a
fault with your appliance and to register your appliance for guarantee purposes.

Appliance Model

Serial Number

CE Declarations of Conformity:

This appliance has been manufactured to the strictest standards and complies with all applicable legislation, including Gas
safety, Electrical safety (LVD) and Electromagnetic interference compatibility (EMC).

IMPORTANT INFORMATION FOR CORRECT DISPOSAL OF THE PRODUCT IN ACCORDANCE WITH EC
DIRECTIVE 2002/96/EC.

At the end of its working life, the product must be taken to a special local authority waste collection centre or to a dealer
providing appliance recycling services.

Disposing of a household appliance separately avoids possible negative consequences for the environment and health. It
also enables the constituent materials to be recovered, saving both energy and resources. As a reminder of the need to
dispose of household appliances separately, the product is marked with a crossed-out wheeled dustbin.

Please note:

• Under no circumstances should the extractor be connected to any gas ventilation system, flue system or hot air

ducting system.

• Do not vent the extractor into an attic or loft space.

• Only house the extractor in rooms with adequate ventilation. Remember that the extractor is powerful and

whatever air is extracted needs to be replaced.

• Do not tile the extractor in. It should be removable for service or maintenance.

• Do not use silicone sealant to secure the hood to the wall.

• You must be able to isolate the extractor from the mains electrical supply after installation.

• This extractor has been designed to be used in a room with a volume of less than 36 m

3

.

• Steam cleaners must not be used when cleaning this appliance.

• The performance of your extractor will vary depending on a number of factors. These include: type of extraction,

length of ducting, room volume, ventilation available and cleanliness of the filters.

1

Using your Extractor

For best performance, you should switch on the extractor 15 minutes before starting to cook and leave it to run for
approximately 15 minutes after the end of cooking.

A - Light switch
B - Power indicator light
C - Power switch

To switch the extractor light on or off

• Slide the light switch to position A1 for off, or A2 for on.

To switch on the extractor, or change the motor speed

• Slide the power switch to the position required dependent on the speed you require.

To switch the extractor off

• Slide the power switch to position C1 for off.

Fig. 1

C2 C4

A B C

A1 C1A2 C3

2

Care and Maintenance

IMPORTANT: DO NOT PERFORM MAINTENANCE

OR CLEANING OF THE EXTRACTOR WITHOUT FIRST

SWITCHING OFF THE ELECTRICITY SUPPLY.

Cleaning

You should use a non-abrasive cleaner. Any abrasive cleaner

(including Cif) will scratch the surface and could erase the

control panel markings.

You can clean you extractor effectively by simply using a

dilute solution of water and mild detergent and drying to a

shine with a clean cloth, for example the CDA E-Cloth.

Cleaning the grease filter

The grease filters should be kept clean to minimise the risk

of fire.

At least once a month you should remove and clean the

grease filters with hot soapy water. You can also wash the

grease filters in a dishwasher, ensuring that you place it in an

upright position to prevent damage from other items in the

dishwasher. After rinsing and drying, replace the filters.

To remove the grease filters, pull open the handle on the

grease filter.. It will release at the handle side. Then lower the

grease filter to remove it completely. To replace the grease

filter, repeat the steps in reverse.

Please note:

Cleaning the grease filters in the dishwasher may lead to

discolouration. This is normal and does not constitute a fault

with the appliance.

Changing the charcoal filter (re-circulating only)

To ensure best performance of your extractor, you should

replace the charcoal filters every four to six months,

depending on use.

To attach a new charcoal filter, first remove the grease filters

as described above. Then offer up the charcoal filter to the

side of the motor as shown in figure 2 and turn it clockwise

until it locks into place. Repeat with the other charcoal filter

on the other side of the motor. Then replace the grease

filters and cover panels.

Fig. 2

3