C. Crane WiFi Hotspot Repeater Quick Start Manual

WiFi Hotspot Repeater Quick Start Guide

C

D

Enter “admin” for the username and “admin” again for the
password. Press “Log In”.

E

Click on the “Easy Setup” tab in the gray bar.

F

Click the dot next to “USB Wireless Adapter”.

2

Continued

1

WiFi Hotspot Repeater Setup Guide

2

Plug in a Compatable
USB Antenna*

3

Connect Power

1

WiFi Hotspot

Repeater

*

You must follow these instructions carefully.

*

A

AC Power
Adapter

Please Note: The USB Antenna Startup Guide &
Installation are not needed to setup the Hotspot.

Open your Internet Browser screen and enter “192.168.2.1”
into the Address Bar. Press “Enter” on your keyboard.

Attach
Antenna
First

Main USB
Cable

Leave
Unplugged

CC X Mile

Long Range

Outdoor USB WiFi

Antenna

Super USB WiFi

Antenna 3

Versa WiFi USB

Adapter 3

*Compatable
USB Antennas

NOTE:

Although the WiFi Hotspot Repeater can be setup
from a Tablet or Smartphone, it is much easier to
use a computer and the supplied Ethernet cable to

Connect to the WiFi
Network named “ALFA_AP” from your WiFi
Network list.

-OR-

Cable: Connect the Ethernet cable between
your computer and the WiFi Hotspot Repeater.
Use the Ethernet port that is closest to your
power connection.

B

WiFi Hotspot Repeater Quick Start Guide

WiFi Hotspot Repeater Quick Start Guide

J

Now you will choose an easy name to call your new WiFi
Network. (Example: “BobsNetwork”). Enter it into the

“SSID Choice” Do not use the same name as the network
you are repeating.

If you cannot access the Setup Screen then you may need to
perform a factory reset. To do this, press the red button on the
bottom for at least 5 seconds while it is powered ON. You may
need to use a toothpick or paperclip to reach it. Allow 30 seconds
for the hotspot to reset and startup before attempting setup again.

Reset Button

Bottom Panel

TROUBLESHOOTING

3

Click on “Site Survey”.

G

Scroll towards the bottom of the page. 1. Click the dot
next to the WiFi Network that you want to repeat, then

2. Click “Select”. Note: For best performance, “signal”

H

I

1. If your selected Network requires a password, then enter
it into the space marked “Pass Phrase”

*. Do not change

any other settings. 2. Click on the “Next” button.

1

4

* If the security mode is WEP, then enter password into

“WEP Key 1”.

2

1

Congratulations, your new Network is ready to use !

Connect to it from the WiFi Network list on your device.
Look for the name that you entered in step

J

and enter the Password that you entered in step

K

1. Choose “WPA-PSK_WPA2-PSK” from the “Security Mode”
dropdown. 2. Choose “Auto (TKIP/AES)” 3. Now create a
wireless password and enter it into the “Pass Phrase”

You must choose a password that contains between 8 and 64
characters. 4. Click on the “Done”

K

1

3

4

2

2

Copyright ©2015 C. Crane All Rights Reserved

must be greater than 30/100.

Please wait for up to one minute.