
CCM Marker - Quick Start Guide:
Congratulations on buying a CCM Marker! We at CCM have taken every effort to give
you a quality marker that is properly adjusted and performing at the highest level. The
marker you have in your hands should serve you for years to come with a little
maintenance and care. With this in mind, please do not disassemble or adjust this
marker before playing with it and understanding what you need to adjust. Even though
we have adjusted this marker – it is your responsibility to make sure it is shooting safely
before you hit the field. In order to do this please follow these steps:
1. Screw barrel onto marker – if your CCM marker does not come with a barrel – use a
barrel with Autococker® threads.
2. Place barrel blocking ‘Barrel Bag’ device properly onto the marker
CAUTION: Always wear paintball approved eye and face protection when dealing with a
pressurized paintball marker.
3. Pull the cocking rod back until it latches into place. You will hear a click when this
happens. If you do not follow this step the marker will leak down the barrel when you
connect the air source.
4. Connect the air source to the ASA (air system adapter.)
Note: Make sure to always get air cylinders filled by authorized, skilled
and knowledgeable technicians for the correct fill limits of each cylinder.
Do not try to refill cylinders by yourself. Do not use cylinders that have not
been properly maintained or that are damaged. It is very important that
caution be exercised when refilling or attaching cylinders.
5. Attach the loader to the feed port of the marker. CCM Markers come with a clamping
feed neck. This feed neck either has a lever style clamping feature or an Allen bolt.
This bolt takes a 5/32 Allen key. Clockwise tightens the band to your hopper.
Note: Use only 0.68 caliber paintballs in your CCM Marker. Do not modify the
paint in any way.
Before field use, ensure the velocity is in compliance with field safety guidelines.
General field velocity limits are usually between 250 fps to 300 fps (fps = feet per
second.) Your paintball markers velocity should never exceed 300 fps. Observe
and abide by all local laws, regulations and field safety guidelines pertaining to
use of paintball markers.

To Adjust Velocity:
CAUTION: Industry approved protective gear (for face and eyes) must be worn at all
times while operating and performing adjustments on this marker.
• If you are uncertain, unable or do not know how to perform work on the marker, have
adjustments and repairs made by a qualified technician.
1. All CCM markers come from the factory with the regulator ‘sweet spotted’. This
means that the regulator is set to its most efficient point. Please do not attempt to
adjust the velocity by using the regulator. If you over pressurize the valve – it will
actually cause the markers velocity to go down not up. If you want to understand
more about the valve and its set up – please read the full CCM Manual.
2. If your marker needs the velocity adjusted – please pump the marker to the most
rear position and hold it there – exposing the IVG for adjustment.
3. Insert the short end of a 1/8” Allen wrench into one of the three holes in the IVG
(Internal Velocity Governor). Turning the Allen wrench clockwise will increase the
velocity while counterclockwise will decrease velocity.
4. Movement of the wrench quarter turn in either direction will approximately yield a 15-
20 fps change.
For how to clean, maintain, or trick out your new CCM marker – please read the manual
that accompanied your marker – or visit www.chipleymachine.com