How to Install the
Cata-Dyne™ Protection Grill
The protection grill provided by CCI Thermal as an optional accessory for the Cata-Dyne™ heater
has been redesigned to allow for easy installation and/or removal. The 12" x 24" grill(s) are fastened
to the bezel assembly. The bezel assembly is the rectangular steel frame riveted around the front of
the Cata-Dyne™ heater. No assembly hardware or tools are required to attach the grill(s).
protection grill into the holes
provided on the heater’s bezel
Step #1
Insert the installation hooks
on the 12” side of the
assembly
Installation Hooks
(on protection grill)
the bezel assembly and snap
the installation hooks into the
Step #2
Pull the protection grill over
holes provided
Installation Holes
(on bezel
assembly)
• To remove the protection grill, perform the above steps in reverse order.
• Exercise care not to damage the heater's catalyst pad when installing or removing the protection grill.
Caution! Do not Attempt to Install or Remove the Protection Grill While the Heater is in Operation.
CCI Thermal Technologies Inc.
Head Office & Factory
5918 Roper Road, Edmonton, Alberta, Canada T6B 3E1
Toll Free: 1-800-661-8529
www.ccithermal.com info@ccithermal.com
December 2007
M20512-010
Loading...