Federal Communication Commission Interference Statement
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is encouraged to try to
correct the interference by one of the following measures:
* Reorient or relocate the receiving antenna.
* Increase the separation between the equipment and receiver.
* Connect the equipment into an outlet on a circuit different from that to which
connected.
* Consult the dealer or an experienced radio/TV technician for help.
REGULATION INFORMATION
The WLAN 11n PCI must be installed and used in strict accordance with the manufacturer’s
instructions. This device complies with the following radio frequency and safety standards.
This device complies with Part 15 of the FCC Rules. Operation is
subject to the following two conditions:
(1) This device may not cause harmful interference.
(2) This device must accept any interference received, including
interference that may cause undesired operation.
FCC RF Radiation Exposure Statement:
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled
environment. End users must follow the specific operating instructions for satisfying RF exposure
compliance.
To comply with the FCC RF exposure compliance requirements, this transmitter must not be colocated or operating in conjunction with any other antenna or transmitter.
Your device contains a low power transmitter. When device is transmitted it sends out Radio
Frequency (RF) signal. In order to maintain compliance with the FCC RF exposure guidelines,
this equipment should be installed and operated with minimum distance 20cm between the
radiator and your body. Use only with supplied antenna. Unauthorized antenna, modification, or
attachments could damage the transmitter and may violate FCC regulations.
You are cautioned that changes or modifications not expressly approved by the part responsible
for compliance could void the user’s authority to operate the equipment.
the receiver is
Europe- R&TTE Compliance Statement
Hereby, CC&C Technologies, Inc., declares that this equipment complies with the essential
requirements and other relevant provisions of DIRECTIVE 1999/5/CE OF THE EUROPEAN
PARLIAMENT AND THE COUNCIL of March 9, 1999 on radio equipment and telecommunication
terminal Equipment and the mutual recognition of their conformity (R&TTE).
CE Declaration of Conformity
For the following equipment:
WLAN 11n PCI
(Product Name)
WL-6400-V2
(Model Designation)
is herewith confirmed to comply with the requirements set out in the Council (Euro pean
parliament) Directive on the Approximation of the Laws of the Member States relating to
Electromagnetic Compatibility of Radio and Telecom device (1999/5/EC). For the
evaluation regarding this Directive, the following standards were applied:
EN 135 328 V1.7.1
EN 301 489-1 V1.6.1 ; EN 301 489-17 V1.6.1
EN 60950-1:2006
EN 50371
This equipment is marked with the
European community. Marking by the symbol
France - 2.4GHz for Metropolitan France:
In all Metropolitan départements, wireless LAN frequencies can be used under the following
conditions, either for public or private use:
· Indoor use: maximum power (EIRP*) of 100 mW for the entire 2400-2483.5 MHz frequency
band
· Outdoor use: maximum power (EIRP*) of 100 mW for the 2400-2454 MHz band and with
maximum power (EIRP*) of 10 mW for the 2454-2483 MHz band
Caution: Exposure to Radio Frequency Radiation.
To comply with RF exposure compliance requirements, for mobile configurations, a separation
distance of at least 20 cm must be maintained between the antenna of this device and all persons.
This device is intended for use as check in the following European Community countries:
Austria Belgium Czech Republic Cyprus
Denmark Estonia France Finland
Germany Greece Hungary Ireland
Italy Iceland Luxemburg Latvia
Lithuania Malta Norway Netherlands
Portugal Poland Spain Sweden
Slovakia Slovenia United Kingdom
symbol and can be used throughout the
indicates that usage restrictions apply.
The channel identifiers, channel center frequencies, and regulatory domains of
each 22-MHz-wide channel are shown in following Table.
France
Outdoor
3
3
3
3
3
3
3
3
3
Israel
3
3
3
3
3
3
3
3
3
3
3
3
3
3
3
3
Channel
Identifier
1
2
3
4
5
6
7
8
9
Frequency
(MHZ)
2412
2417
2422
2427
2432
2437
2442
2447
2452
Regulatory Domains
Japan
ETSI
3
3
3
3
3
3
3
3
3
3
3
3
3
3
3
3
3
3
North
America
Mexico
10
11
12
13
14
3
2457
2462
2467
2472
2484
3
3
3
3
3
3
3
3
3
3
3
3
Thank you for your purchase of the WLAN 11n PCI. Featuring wireless
technology, this wireless networking solution has been designed for both
large and small businesses, and it is scalable so that you can easily add
more users and new network features depending on your business scale.
FEATURES
z Support Microsoft 2000, XP, x64 and Vista.
z Operating distance of up to 300 meters in free space.
z 135/121.5/108/81/65/58.5/54/52/48/40.5/39/36/27/26/24/19.5/18/13.5/
z 64/128-bit WEP , WPA (Wi-Fi Protected Access), WPA2
z 2.400GHz ~ 2.484GHz unlicensed ISM Frequency
z IEEE 802.11b : DSSS (Direct Sequence Spread Spectrum).
z IEEE 802.11g / 802.11n : OFDM (Orthogonal Frequency Division
13/12/9/6.5/6/5.5/2/1 Mbps selectable Data Rate.
Band. Modulation Method :
Multiplexing).
zEasy operation and setting up.
SYSTEM REQUIREMENTS
Windows System : 2000, XP, x64, Vista.
PCs must have a device driver installed. It allows you to communicate
with WLAN 11n PCI.
1
BEFORE YOU START
1. Confirm Box Contents
◆ WLAN 11n PCI
◆ Quick Start Guide
◆
Driver CD
INSTALL YOUR WLAN 11n PCI TO PC
Quick Start Guide
Install your WLAN 11n PCI into your PC.
Install driver.
GETTING TO KNOW WIRELESS LAN ADAPTER
LED
LED turns on when WLAN link to WLAN adaptor or AP.
LED is blinking when WLAN Adapter is active.
2
Loading...
+ 17 hidden pages
You need points to download manuals.
1 point = 1 manual.
You can buy points or you can get point for every manual you upload.