CC and C Technologies WA6206 Users Manual

Page 1
Version: 1.0s
User’s Manual
Version: 1.0s
i
Page 2
Version: 1.0s
Trademarks
Copyright @2007 Contents are subject to change without notice. All trademarks belong to their respective proprietors.
Copyright Statement
THIS DOCUMENT CONTAINS OF PROPRIETARY TECHNICAL INFORMATION THAT IS THE PROPERTY OF THIS COMPANY. AND NO PART OF THIS DOCUMENTATION MAY BE REPRODUCED, STORED IN A RETRIEVAL SYSTEM OR TRANSMITTED IN ANY FORM OR BY ANY MEANS, ELECTRICAL OR MECHANICAL, BY PHOTOCOPYING, RECORDING, OR OTHERWISE, WITHOUT THE PRIOR WRITTEN CONSENT OF THIS COMPANY.
Federal Communication Commission Interference Statement
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interfer ence to radio or television reception, which can be determined by turning the e qui pment off and on, the user is enco uraged to try to correct the interference by one of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) T his device may not cause harmful interference, and (2) this device must accept any interference received, including interfer ence that may cause undesired operation.
FCC Caution: Any changes or modifications not expressly approved by the party responsi ble for compliance could void the user's authority to operate this equipment.
IMPORTANT NOTE: FCC Radiation Exposure Statement:
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance 20cm between the radiator & your body. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.
ii
Page 3
Version: 1.0s
Trademark
All of the company or product names mentioned in this manual are the trademarks or registered trademarks of their respective holders.

Disclaimer

All of the contents in this manual, product specifications, size and shape are subject to change without prior notice.
The manufacturer makes no representations or warranties with regard to the contents hereof and reserves the right to revise this manual without obligation to notify any person. The manufacturer shall not be liable for any technical or editorial errors or omissions contained in this manual, or for any damage, direct or indirect, from discrepancies between the manual and the product it describes. The manufacturer assumes no responsibility, directly or indirectly, for financial losses or claims from third persons resulting from the use of this product and any of its functions. Total accessible cap acity varies depending on operating environment. All references to speed are for comparison purposes only. Actual data throughput will vary.

Precautions

Please follow the precautions listed below. Failure to do so may cause damage to the device and void the warranty.
* Read this User’s Guide carefully and follow the procedures for installing and using the device. * Do not open the device or attempt to disassemble or modify it. If it appears to be malfunctioning,
contact Technical Support.
* Never expose the device to water or other liquids or in damp or wet conditions in order to avoid
danger of electric shock, short-circuiting or personal injury. * Place the power adapter and the power cord such a way that people cannot step on it. * Do not use a third-party AC adapter or power cord. * Do not cover the openings; the openings on the equipment are for air convection hence protects the
equipment from overheating. * If any of the following situations arises, have the equipment checked by service personnel:
- The power adapter, power cord or power connector is damaged.
- Liquid has penetrated into the equipment.
- The equipment has dropped and damaged.
- The equipment has obvious sign of breakage.
iii
Page 4
Version: 1.0s
Copyright Notice
The material in this document is the intellectual property of Samtack Computer Inc. We take every care in the preparation of this document, but no guarantee is given to the correctness of its contents. Our products are under continues improvement and we reserve the right to make changes without notice.
Limited Warranty
This product is warranted against manufacturing defects for the period of one year. The warranty period commences on the date of purchase from authorized reseller/retailer. Your original purchase invoice, showing the date of purchase of the product is your proof of the date of purchase.
During the warranty period, defective parts will be repaired or replaced. There will be no charge for labor or parts during the one-year warranty period from the date of purchase. Any shipping or other cost such as customs incurred costs, etc…. is customers’ responsibility.
This warranty does not cover any failure resulting in loss to software, data, lost profits, lost savings, any incidental damages or other economic consequential damages due to accident, abuse, misuse, negligence and acts of God.
Technical Support and Service
For technical support in English Email stsuport@samtack.com Call 1-800-255-8048 Monday to Friday (except holidays) 09:00am to 08:00pm (Eastern Time)
For technical support in French Email soutien@samtack.com Call 1-800-541-2799 Monday to Friday (except holidays) 0900:am to 05:00pm (Eastern Time)
iv
Loading...