CBC ZN-DT Series, ZN-DT2MA, ZN-DT1MA, ZN-DT1A Quick User Manual

Quick User Guide ZN-DT Series Network Camera



1

Warning before installation

-Power off the Network camera if it is found to be smoking or smells unusual.

-Keep the Network camera away from water. If the Network camera gets wet, power
off immediately.

-Do not place the Network camera near heat sources, such as a television or oven.

-Refer to your instruction manual for the operating temperature.

-Keep the Network camera away from direct sunlight.

-Do not place the Network camera in high humidity environments.

-Do not place the Network camera on unsteady surfaces.

-Do not touch the Network camera when there is lightning present.

-Do not disassemble the Network camera.

-Do not drop the Network camera.

-Do not insert any object into the Network camera, such as a screwdriver.

For other safety and regulation information, please refer to “User’s manual”.

1. Check Contents

No.

Item

Description

1

Network Camera

ZN-DT Series (ZN-DT2MA / ZN-DT1MA / ZN-DT1A)

2

Software CD

User’s Manual, Utility software

3

Quick User Guide

This document

4

Accessories

Bottom Cushion Plate
Both-sided Tape
Silica-Gel
Anchor : 4pcs
Oring : 8pcs
Tapping Screw 4x30 : 4pcs
Screw M5x5 : 4pcs
Hexalobular L-key Wrench
Alarm I/O extension cable

2. Physical Description

Alarm In / Out conne
ctor

1. Network (RJ-45 PoE supported)

2. Video Out

3. Audio In (Line in)

4. Audio Out (Line Out)

5. Alarm In / Out connector (Dry contact / Relay out [2A:AC120V/DC60V])

Quick User Guide ZN-DT Series Network Camera



2

6. Power (DC12V / AC24V)

7. Micro SD card (SDHC supported)

8. Reset Button

9. Status LED

10. Video output for service monitor

3. Making Connection

1. If you have external devices such
as sensor or alarms, make connection
from connectors

2. Connect Ethernet cable to make connection

to the network hub.

3. Connect power cable to the camera.

When you use PoE function, you don’t

need to connect power.