CBC ZN-BxMTP Series Quick User Manual

Quick User Guide ZN-BxMTP Series Network Camera

1

No.

Item

Description

1

Network Camera

ZN-BxMTP Series

2

Software CD

User’s Manual, Utility software

3

Quick User Guide

This document

4

Accessories

Template for installation
Anchor : 4pcs
Tapping Screw 4x30 : 4pcs
O-ring : 4pcs
Hexalobular L-key Wrench
Wrench bolt 3pcs
Video monitor cable
Power Jack Cable
Terminal Block (2pin/8pin)

Warning before installation

-Power off the Network camera if it is found to be smoking or smells unusual.

-Keep the Network camera away from water. If the Network camera gets wet,
power off immediately.

-Do not place the Network camera near heat sources, such as a television or
oven.

-Refer to your instruction manual for the operating temperature.

-Keep the Network camera away from direct sunlight.

-Do not place the Network camera in high humidity environments.

-Do not place the Network camera on unsteady surfaces.

-Do not touch the Network camera when there is lightning present.

-Do not disassemble the Network camera.

-Do not drop the Network camera.

-Do not insert any object into the Network camera, such as a screwdriver.

For other safety and regulation information, please refer to “User’s manual”.

1. Check Contents

Ver1.20 EN

Quick User Guide ZN-BxMTP Series Network Camera

2

2. Physical Description

1. Network (RJ-45 PoE supported)

2. Power connector (24VAC: Heater)

3. I/O signal terminal
Audio In (Line in)
Audio Out (Line Out)

Alarm In (Dry Contact)
Alarm Out (Relay out [0.5A:125VAC / 1A:30VDC])

4. Micro SD card (SDHC supported)

5. Control Button

6. Video output for service monitor/Status LED

3. Making Connection

1. If you have external devices such as sensor or alarms, make connection
from connectors.

2. Connect Ethernet cable to make connection to the network hub.

3. Connect power cable to the camera.

Please refer to User’s manual in software CD.

Ver1.20 EN