Page 1
facade BED - QUEEN
Thank you for purchasing the Facade Queen Bed.
This page
Please take the time to identify the hardware as well as
the individual components
unpack and prepare for assembly, place the contents
on a carpeted or padded area to protect them from
damage.
Note: 2 people are required to safely assemble this product.
lists all the contents included in the box.
to this product. As you
hardware
39 - screws 2 - spacers
Missing hardware?
Please call 800.606.6387 for replacements.
tools required
phillips head screwdriver
(We recommend the use of hand tools instead of power tools)
components
1 - headboard
1 - footboard
2 - side rails
(1 left, 1 right)
2 - center
support legs
13 - slats
1 - center
support
Made in USA - r07 Page 1 of 3
Customer Service 800.606.6252 | Latest instructions available at www.cb2.com
Page 2
facade BED - QUEEN
headboard
footboard
right side
rails
left side
rail
right side
rail
With the assistance of another adult, lift both ends
of side rail so it is the same distance from the floor.
At this point, insert pegs of each side rail into
corresponding holes in each bracket of headboard
as shown. Push down firmly at each bracket until
1 2
it locks into position.
slat
center
support
left side
rails
Attach brackets of left/right side rails into
corresponding brackets of footboard as shown.
center support
assembly
center
support
leg
Attach 2 slats to center support with 1 screw per
slat as shown. Secure, but do not over tighten,
3
screw with a phillips head screwdriver.
Made in USA - r07 Page 2 of 3
Customer Service 800.606.6252 | Latest instructions available at www.cb2.com
Attach 2 center support legs to center support
assembly as shown. Turn each support leg
4
clockwise to secure.
Page 3
facade BED - QUEEN
Align slats so they are parallel to the headboard
and footboard. Secure assembly with 4 screws as
shown. Make sure center support is securely
supported by each support leg.
5 6
spacer
Attach remaining 11 slats to center support rail
with 3 screws per slat as shown. Before securing
each screw to side rails and center support, use
the spacer to determine spacing between slats as
shown.
Assembly is now complete.
CLEANING AND CARE
Fabric cleaning code S: to prevent overall soil, frequent vacuuming
or light brushing to remove dust and grime is recommended.
Spot clean using a mild water-free solvent or dry cleaning product.
Clean only in a well ventilated room and avoid any product
containing carbontetra-chloridewhich ishighlytoxic.
Pretest small area before proceeding.
Cleaning by a professional cleaning service is recommended.
Made in USA - r07 Page 3 of 3
Customer Service 800.606.6252 | Latest instructions available at www.cb2.com
Loading...